Eizo ColorEdge CG242W - Manual (Page 24)


4.Troubleshooting
Problems Possible cause and remedy
• The message below shows that the input signal is out of
the specified frequency range. (Such signal frequency is
displayed in red.)
Example:
• Check whether the signal setting of your PC matches
the resolution and the vertical frequency settings for the
monitor (
page 11 ).
• Reboot the PC.
• Select an appropriate display mode using the graphics
board’s utility. Refer to the manual of the graphics board
for details.
fD: Dot Clock
(Displayed only when the digital signal inputs)
fH: Horizontal Frequency
fV: Vertical Frequency
3. Display position is incorrect. • Adjust image position so that it is displayed properly
within the display area using the <Position> adjustment
(
page 15 ).
• If the problem persists, use the graphics board’s utility if
available to change the display position.
4. Screen image displayed is smaller or larger than the
actual screen image.
• Adjust the resolution using <Resolution> so that the
input signal resolution equals the resolution in the
resolution adjustment menu (
page 15 ).
5. Vertical bars appear on the screen or a part of the image
is flickering.
• Adjust using <Clock> ( page 14 ).
6. The characters and images have several vertical bars on
their right side.
• Adjust the characters and images using the
<Signal Filter>.
7. Whole screen is flickering or blurring. • Adjust using <Phase> ( page 14 ).
8. Characters are blurred. • Adjust using <Smoothing> ( page 19 ).
9. Upper part of the screen is distorted as shown below. • This is caused when both composite sync (X-OR)
signal and separate vertical sync signal are input
simultaneously. Select either composite signal or
separate signal
10.The screen is too bright or too dark. • Adjust <Brightness>. (The LCD monitor backlight has a
fixed life span. When the screen becomes dark or begins
to flicker, contact your local dealer.)