Nuvo Simplese NV-A4DS-UK - Manual (Page 13)

10
IV. Installing the Simplese Amplifier
The Simplese amplifier component is designed to be
placed on a shelf or in a component rack. Rack ear
mounts are supplied with the system. If you are
using the rack ears and mounting the amplifier with
other components, you should remove the feet.
Remove the two screws at the front of each side of
the lid and use the longer screws included with the
rack ears to attach the ears to the Simplese
amplifier.
The audio sources are plugged into the four source
inputs on the back panel of the Simplese amplifier
using stereo RCA cables, fig. 4.
V. IR Outputs
The Simplese System ships with four IR emitters for
transferring IR data from the keypad receivers
(located under the volume button) to the IR receiver
on each piece of source equipment. There are two
separate IR output sections on the back panel. The
38Khz outputs are used for most audio sources. The
exception to this is cable and satellite boxes, which
operate at a higher IR carrier frequency closer to
56Khz. A second source one and two 56Khz output is
available for these devices. It is important that the
output being used for each source matches the
source input number. The outputs work individually
with each source to allow independent source
control. Simply plug the emitter into the appropriate
IR output on the back of the Simplese amplifier and
attach the flasher end over the IR receiver of the
source equipment, fig. 5.
VI. Keypad and Zone Setup
Each keypad requires a specific zone setting to
establish the keypad's location. This setting is made
on the back of the keypad using an eight-position
rotary switch. To set the switch, place a small slot-
head screwdriver in the slot in the switch and turn it
clockwise to the appropriate zone number 1-4, fig.
6. The remaining switch positions, 5-8, allow for an
additional keypad in each zone. Position 5
corresponds to zone 1, 6 to zone 2, 7 to zone 3, and 8
to zone 4. The additional letters do not apply to
Simplese. Note that the Allport only has four RJ45
jacks, so additional keypads require the use of a
CAT5 splitter.
Fig. 4
Fig. 5
Fig. 6
SOURCE INPUT
L
R
L
R
1 2 3 4
L
R
ZONE 4
FIXED VAR
LINE OUT
Source 1
Tuner 1
Audio
Out
SOURCE INPUT
L
R
L
R
1 2 3 4
L
R
ZONE 4
FIXED VAR
LINE OUT IR OUT
1 3
2 4
USE FOR SAT OR CABLE NORMAL USE
56KHz 38KHz
1
2
Network Zone
Address Connection
Use only with
NuVo Simplese System
WARNING:
AVIS: Utiliser uniquement avec
NuVo Simplese System
NuVo Technologies LLC Hebron, Kentucky USA
www.nuvtoechnologies.com
Local Source
Simplese Keypad
Model NV-A4DKP-UK
0 12 F 3 E 4 D 5
C 6 7 B 8 A 9