NordicTrack 831.159760 - Manual (Page 16)

16
50
3
72
8
35
62
Slot
32. Attach a 4” Pulley (35) inside the slot in the Leg Lever
(29) with a 3/8” x 2 1/2” Bolt (54), two 3/8” Flat
Washers (55), two 5/8” x 1/2” Pulley Bushings (42),
and a 3/8” Nylon Jamnut (63).
Attach the 1/2” x 1 3/4” Bushing (94) inside the bot-
tom of the Leg Lever (29) with a 5/16” x 2 1/2” Bolt
(96), two 5/16” Flat Washers (80), and a 5/16” Nylon
Jamnut (79).
Refer to the inset drawing. Press the Tab (93) onto
the cage as shown. Secure the Tab with a 1/4” x 1”
Bolt (95), a Large Washer (104), and a 1/4” Nylon
Locknut (25).
Make sure that the Low Cable (72) is
on top of the Tab and the 1/2” x 1 3/4” Bushing (94).
Press a 2” Square Inner Cap (33) into the bottom of
the Leg Lever (29).
Note: It may be easier to attach
the 2” Square Inner Cap and the 1/2” x 1 3/4”
Bushing (94) if you pivot the Leg Lever upward.
33. Route the Low Cable (72) through the indicated slot
in the Main Upright (3) and the Base (8).
Wrap the Low Cable (72) around a 4” Pulley (35) in
the direction shown. Attach the Pulley inside the
bracket on the Main Upright (3) with a 3/8” x 2” Bolt
(62) and a 3/8” Nylon Locknut (50) as shown.
34. Wrap the Low Cable (72) over a 4” Pulley (35). Slide
the Pulley and a Cable Trap (44) between the two
Pulley Plates (31).
Make sure the Cable is in the
groove of the Pulley and that the Cable Trap is
oriented so it will hold the Cable in place.
Attach the 4” Pulley (35) and the Cable Trap (44) to
the lowest holes in the Pulley Plates (31) with a 3/8” x
1 3/4” Bolt (60) and a 3/8” Nylon Jamnut (63).
33
32
63
79
54
96
29
33
42
94
Slot
42
55
55 72
35
95
104
25
72
80
Cage
Bracket
31
35
72
34
Adjustment
Holes
44
60
63
93
35. Wrap the Low Cable (72) around a 4” Pulley (35).
Attach the Pulley to the front hole in the bracket on
the Main Upright (3) with a 3/8” x 2” Bolt (62) and a
3/8” Nylon Locknut (50).
35
3
50
72
62
35