Nady Systems SRM-10X - Manual (Page 10)

c. Monitor Function and Operation
(38) AUX TO METER AND CTRL R/PHONES
(42) AFL SWITCH
(22) CONTROL ROOM OUTPUT
(21) PHONES OUTPUT
(39) PHONES/CONTROL ROOM CONTROL
Depressing the AUX TO METER AND CTRL R/PHONES
button (38) allows the Aux Send output signal to be
directly monitored by the Meter Display and the
Control Room / Headphone outputs. This button
overrides the AFL switch.
[Note: When this button is depressed, all PFL
switches should be in the off (up) position]
When depressing the AFL switch (42), the Meter
Display and Control Room/Headphone outputs will
monitor the Mono output signal.
The SRM-10X allows you to monitor the Master Mix. The
signal level is adjusted with the Headphone/Control Room
level (39) and routed to both the Control Room (22) and
Phones (21) output. The Control Room Output (22) can be
connected to an amp to power stereo control room (or other)
monitor speakers and is 1/4" stereo jack. Both Control Room
(22) and Phones (21) outputs are wired: Tip = left signal, ring
= right signal, sleeve = ground.
d. Power Switches
(43) AC POWER IN SOCKET
(44) MAIN POWER SWITCH
(35) POWER ON LED INDICATOR
Once the external PSU is connected to the AC Power In
socket (43) and then to the AC power source, you may
switch on your mixer with the Power On switch (44). The
Power "ON" LED (35) will light up. Allow 1 minute after
powering up for the system to reach equilibrium before setting
inputs gains and other levels.
(33) PHANTOM POWER SWITCH
(34) PHANTOM POWER ON LED INDICATOR
When using condenser mics, +48VDC can be switched
globally on or off to the XLR mic inputs for all mono channels
(also see MONO INPUT SECTION, MIC INPUTS). When this
switch is in the "ON" position, the Phantom Power On LED
Indicator (34) will light , and +48VDC will be provided
between pins 2 and 3 on all the mono Mic input XLR
connectors. If you don’t need phantom power, be sure to turn
this switch to the "OFF" position.
[Note: It is safe to connect balanced dynamic mics or line
level devices even if this switch is on, but connecting
unbalanced devices or devices whose transformers are
center-grounded will cause hum or malfunctions. Shorting the
+48VDC can also damage your mixer. Also, mute the
Monitor/PA speakers when turning the phantom power on or
off.]
C O N T R O L S A N D C O N N E C T I O N S
10
(36)
BACK PANEL
(33)
(37)
(41)
(42) (39)
(38)
(43) (44)
(31)
(32)
(35) (34)
(40)