NordicTrack NTL2295.0 User Manual
Page 8
8
5. Cut the tie securing the wires to the right Upright (20).
Have a second person hold the console assembly near the
Uprights. Connect the Upright Wire Harness (73) and the
Pulse Wire (74) to the wires extending from the console as-
sembly.
The connectors should slide together easily
and snap into place. If they do not, turn one connector
and try again. Insert the connectors into the console as-
sembly. If necessary, remove the right accessory tray (not
shown) from the console assembly.
Connect the Upright Ground Wire (113) to the ground wire
extending from the console assembly. Make sure that the
wires are fully inserted into each other. Insert the ground
wires into the console assembly. Reinsert the right acces-
sory tray (not shown) into the console assembly if neces-
sary.
20
73
Console
Assembly
Ground
Wire
74
113
73
74
5
6. Set the console assembly on the Upright (20).
Make sure
that no wires are pinched. Finger tighten a Console Bolt
(72) with a Star Washer (67) into the lower hole in the
Upright. Repeat on the other side.
Next,
finger tighten a Short Console Bolt (112) with a
Star Washer (67) into the upper hole in the Upright (20).
Be careful not to drop the Short Console Bolts into
the Uprights. Repeat on the other side. Firmly tighten the
two Console Bolts (72) and the two Short Console Bolts.
Repeat on the other side.
Insert the Upright Endcaps (71) into the top of each
Upright (20) (only one side is shown). Note: Insert the end
of the Upright Endcap indicated by the arrow first; use a
rubber mallet if necessary.
112
20
71
67
67
72
Console
Assembly
6
7. Slide the two Upright Covers (75) onto the lower ends of
the Handrails (68, 70). Next, align the slots in the lower
ends of the Handrails with the holes in the Upright (20) as
shown.
Do not drop the Handrails into the Upright or
cut the indicated black tie.
Next, loosely thread four Handrail Bolts (66) with Star
Washers (67) into the Handrails (68, 70) and the Upright
(20).
Make sure that the Handrails are centered in the
Upright, and firmly tighten the four Handrail Bolts.
20
20
75
68
70
67
66
75
Do
Not
Cut
7
66
67