NEC RWC-4717 - Manual (Page 6)

MODE button
Each time MODE button is pressed, the operation
mode is changed in sequence:
COOLING
FAN ONLY ENERGY SAVING COOLING
NOTE: After setting the mode, allow 3
minutes before switching to another mode.
NOTE: Temperature setting range is from 19 (66 ) to 31 (88 ).
FAN SPEED button
Used to select fan speed in sequence auto, low,
medium and high.
SWING button
Used to select start or stop vertical air vanes swinging.
TIMER button
Used to set or cancel timer operation.
When the unit is in operation, you can set OFF TIMER.
When the unit is off, you can set ON TIMER.
Timer setting range is 0 to 24 hours.
If the OFF TIMER is set, the timer LED displays
the remaining time to turn off the unit for only
12 seconds, then LED shifts to display set temperature.
If the ON TIMER is set, the timer LED displays
the remaining time to turn on the unit.
If you want to cancel ON TIMER, press TIMER button again.
Used to set room temperature in COOLING mode or used to set time in TIME R mode.
If the two keys are pressed at the same time,the temperature LED display will alternate between
and .
ON/OFF button
The air conditioner will be started when it is energized
or will be stopped when it is in operation, if you press
this button.
You can easily operate this air conditioner by pressing
relevant button on the control panel as well as the
remote controller.
Indication symbols of LED on control panel:
High fan speed
Medium fan speed
Low fan speed
Auto fan speed Cooling
Fan only
Display set temp
Display set timer
Timer
Above LED lights on when the relevant mode is in used.
Energy-saving
Button
Control Panel
SWING
OFF ON / MODE TIMER
FAN
SPEED
F
HR
C C
C
HR
But the mark of " "or" "you can not change.Usually ,those models used 220V~/50Hz marked with
" ",others models marked with " ".
Remote Control Model
5
Operating Instructions