Nokia 30 - Manual (Page 14)

12/18
Output_Set All On Set all outputs ON
Output_Set All Off Set all outputs OFF
Supply_Pwr_Get Return a state of supply power
Supply_Pwr On Set supply power ON
Supply_Pwr OFF Set supply power OFF
7.2 DETAILED COMMAND INFORMATION AND RESPONSES
Note that all example commands use the Nokia 30 identifier string and the password
property is set off in all following chapters.
Note: If a command string is not identified but the Identifier and the optional Password are
ok, the terminal will send a following response to the command originator:
E.g.
Nokia30 passWORD ResetAll -> ERROR (Unknown Command)
7.2.1 Change_Pword
The Change_Pword command is used to control password property (see Table 3).
Table 3 Command templates for the password
Command type Command template Comments
Changing Password Nokia30 passWORD Change_PWord wordPASS
OK Response:
CHANGE_PWORD: OK
Fail Response:
CHANGE_PWORD: FAILED (Invalid new password)
The example
changes the
password from
‘passWORD’ to
‘wordPASS’
Activating Password
Property Nokia30 Change_PWord wordPASS
OK Response:
CHANGE_PWORD: OK
Fail Response:
CHANGE_PWORD: FAILED (Invalid new password)
The example
changes an empty
password to
‘wordPASS’
Deactivating
Password Property Nokia30 wordPASS Change_PWord
OK Response:
CHANGE_PWORD: OK
Fail Response:
CHANGE_PWORD: FAILED (Invalid new password)
The example
changes the
password from
‘wordPASS’ to an
empty