Eizo eClient LCD Monitor Integrated Windows-based terminal 630L - Manual (Page 78)

English
78
6. USING THE TERMINAL PROPERTIES
78
6-4. Network Settings
Click [Network] tab to set network information for the 630L.
NOTE
• All settings shown here are previously adjusted on the “WBT Setup Wizard”.
• Please set the properties depending on the 630L connection settings.
[Use PPP connection or another network adapter]
...................................Click to use a modem connection to the WTS.
To connect to the WTS with a LAN network, set the following.
[Obtain an IP address from a DHCP server]
...................................This allows the user to receive IP information from a
DHCP service automatically. The DHCP service of a
server must be in operation to receive the information.
[Specify an IP address.] .......If not using a DHCP service, please select this and
enter the information shown below.
[IP address].........................Type the 630L IP address.
[Subnet Mask] ....................Type the subnet mask.
[Gateway]...........................Type the Gateway IP address.
[Terminal Name] ................Type a name to recognize this unit from others on the
network. (Only in use of the RDP protocol)
[Media Type]......................Set up the transmission speed on the network.