Nady Systems Wireless Guitar Kit - Manual (Page 7)

WGA-15 Wireless Guitar Amp Operation
Front Panel
(11) POWER SWITCH — Turns on power to the amplifier. Make sure unit is plugged into AC and the Level control is
turned down before turning on the amp.
(12) POWER LED — Lights red to indicate the power is on.
(13) TX LED — Lights green to indicate the guitar transmitter is on, within range, and the RF signal is being being re-
ceived.
(14) AUDIO LED — Lights amber to indicate audio is present.
(15) PHONE JACK — This jack should be used for headphones. When plugging into this jack, the internal speaker is
disabled.
Note: This jack is meant to receive a stereo headphone 1⁄4” TRS plug. Do not plug a mono 1⁄4” TS plug into this jack
(16) INPUT JACK — Use this jack to plug in the guitar cord when not in wireless operation. Plugging into this jack will
automatically disable the wireless receiver capability.
(17) GAIN CONTROL — This control adjusts the input gain of the guitar audio. Turn this control to minimum for clean
sounding guitar. Turn it to maximum for heavy distortion. Blues style distortion can be achieved by setting this control to
mid.
(18) LEVEL CONTROL — This control adjusts the final master volume of the audio.
(19) TREBLE CONTROL — This control adjusts the treble frequencies (approx 5K Hz) to increase high cut, presence,
and add definition to your sound.
(20) BASS CONTROL — This control adjusts the bass frequencies (approx 120 Hz) for warmer sound and stronger low
end.
(21) ANTENNA — The antenna wire is dressed inside the amp cabinet. Do not remove or reposition this wire.
(11) (12)
(13) (14) (15)
(20) (19) (18) (17) (16)
Specifications
(21)
Back of WGA-15
(6) (7)
Built-In Wireless System
RF Transmission Frequency: 171.90MHz (Ch A)
Frequency Response: 40-20,000 Hz, +/-3dB
Dynamic Range: 100dB
Total Harmonic Distortion: <0.65%
Operating Range: up to 200+ ft. line-of-sight
Transmitter Batteries: Two 9V alkaline, 26mA drain, up to 30
hours battery life
Controls and Indicators:
Lightning Guitar (transmitter): Transmitter ON/OFF rocker
switch with integrated LED “ON” indicator (LED dims below
6.9V indicating need for battery change). Transmitter not op-
erational if cord is plugged into guitar OUTPUT jack
WGA-15 (receiver): Amp power/Receiver ON/OFF rocker
switch LED indicators: Power ON, TX ON (transmitter signal
received), and AUDIO ON (audio signal from guitar received)
Receiver not operational if cord is plugged into amp INPUT jack
Transmitter and Receiver Antennas: Both internal to guitar and
amp respectively
WGA-15 Guitar Amp
Power Output: 15 Watts RMS @ 4Ω
Speaker: 5” full-range guitar speaker
Impedance: 4Ω
Power handling: 20 Watts
Guitar Input Connector: 1/4” TS mono connector
Input Impedance: 200KΩ
Headphone Output Connector: 1/4” TRS stereo connector
Bass Control: +/- 12dB @ 120Hz
Treble Control: +/- 12dB @ 5KHz
Power Requirements: 115VAC 60Hz
Internal Fuse: 0.5A 250V
Dimensions HWL: 11.8” x 5.7” x 7.4”
Weight: 10.5 lbs