Nautique 230 - Manual (Page 147)

4-71
Controls and Indicators
Rearview Mirror Adjustment
The rearview mirror can be positioned on the windshield to
observe a skier and traffic behind you. The mirror should be
lowered when trailering or when using a mooring cover. To
reposition the mirror bracket on the windshield frame, loosen the
three socket head screws and reposition and tighten the screws in
the new location. The center screw (A) should be tightened two
turns, followed by the two outside screws (B) being tightened two
turns. Follow this sequence until all three screws are tight.
The mirror is installed onto the bracket with a friction clamp (C) to
allow mirror adjustment. The friction is controlled by tightening or
loosening the friction clamp bolt and manually positioning the
mirror to the desired view.
FRICTION CLAMP
SOCKET HEAD SCREWS
CORC0254
A
B
CORC0253
C
V-Drive Sec 4_2010.qxp:Naut Air Sec 4.qxd 7/22/09 1:45 PM Page 71