NordicTrack COMMERCIAL NTEL16907.0 - Manual (Page 7)

7
4. Apply a generous amount of the included
grease to the Pivot Axle (33) and to two 5/8"
Wave Washers (102).
Tip: Avoid pinching or damaging the Upper
Wire Harness (97). Insert the Pivot Axle (33)
through the Upright (6). Then, slide a 5/8" Wave
Washer (102) onto each end of the Pivot Axle.
Slide an Upper Body Arm (12) onto the left side
of the Pivot Axle (33). Attach the Upper Body
Arm with a 5/16" x 1" Patch Screw (81), a Large
Axle Cover (94), and a 5/16" Washer (104).
Attach the other Upper Body Arm (12) in the
same way.
4
3. Tip: Be careful not to pinch the Wire
Harnesses (97, 54) during this step. Start all
screws before tightening any of them.
While a second person holds the Upright (6)
near the Frame (1), connect the Upper Wire
Harness (97) to the Lower Wire Harness (54).
Attach the Upright (6) to the Frame (1) with four
5/16" x 1" Patch Screws (81) and four 5/16"
Split Washers (105).
3
Avoid pinching the
Wire Harnesses (97,
54) during this step
81
81
105
105
54
97
81
94
12
12
102
102
94
33
6
Grease
6
1
97
81
104
104