NordicTrack NTBE01490 - Manual (Page 7)

7
5. Attach the Backrest Adjustment Bracket (19) to the
bracket on the Bench Frame (3) in the following way:
Lubricate an M10 x 115mm Bolt (24). Slide an M10
Washer (4) onto the Bolt and insert the Bolt through
the indicated tube of the Backrest Adjustment
Frame (19).
Hold the Backrest Adjustment Frame (19) over the
bracket on the Bench Frame (3). Insert the M10 x
115mm Bolt (24) through one side of the bracket.
Slide the 15mm x 10.5mm x 60mm Spacer (26) onto
the Bolt. Next, insert the Bolt through the other side
of the bracket and the other tube of the Backrest
Adjustment Bracket. Secure the Bolt with an M10
Washer (4) and an M10 Nylon Locknut (6). Do not
overtighten the Nylon Locknut.
5
4
19
26
3
6
4
24
16
6. Lubricate an M10 x 180mm Bolt (13). Attach the
Backrest Tubes (16) to the indicated tube on the
Bench Frame (3) with the Bolt, two M10 Washers (4),
and an M10 Nylon Locknut (6). Note: Do not over-
tighten the Nylon Locknut; the Backrest Tubes
must pivot easily.
6
4
16
6
4
3
13
7. Attach the Backrest (9) to the Backrest Tubes (16)
with four M6 x 55mm Bolts (2) and four M6
Washers (18). 7
18
18
2
9
18
16
2
Lubricate
Bracket
Lubricate
Tube
4. Press two 20mm x 40mm Inner Caps (17) into each
Backrest Tube (16). Press four 20mm x 40mm Inner
Caps (17) into the Backrest Adjustment Frame (19).
Lubricate an M10 x 180mm Bolt (13). Attach the
Backrest Tubes (16) to the welded tube on the
Backrest Adjustment Frame (19) with the Bolt, two
M10 Washers (4), and an M10 Nylon Locknut (6).
Make sure that the Backrest Tubes are turned as
shown. The indicated holes are not centered in
the Backrest Tubes but are closer to one side.
Turn the Backrest Tubes so the holes are closer
to the floor. Do not overtighten the Nylon
Locknut; the Backrest Tubes must pivot easily.
4
17
17
4
6
19
Lubricate
4
Holes
Welded
Tube
17
17
13
16