Nikon RADIUS CM200 - Manual (Page 43)

Chapter 4
RADIO TUNING AND PROGRAMMING
1.0 Introduction
This chapter provides an overview of the Customer Programming Software (CPS) and tuner
program designed for use in a Windows 98/ME/NT/2000 environment.
Table 4-1 Software Installation Kits Radio Tuning Setup
2.0 CPS Programming/Flashing Setup with RIB
The CPS programming setup, shown in Figure 4-1 is used to program and flash the radio using the
Radio front Telco connector.
NOTE Refer to the CPS on-line help files for programming procedures.
Description Kit Number
CPS RVN4191_
Figure 4-1 CPS Programming/Flashing Setup with RIB
RIB
RLN-4008 Rx
Gnd
Data
Tx Data
Cable 3080369B72 (9 PIN)
DB15
Cable 3080369B71 (25 PIN)
Power
Supply
Programming
3080070N01
Cable
DB25
R
adio DC
RF
ACC
FKN8096
8-pin Telco
10-pin Telco
FKN8096
Data =Programming
Boot = Flashing