Preparation before use – NEC RIH-6867 User Manual
Page 3
Preparation before use
Note:
If the air conditioner you purchased is a Cooling Only one, but you preset the remote controller as Heat Pump, it will not
operate. But if the air conditioner you purchased is a Heat Pump one, and you preset the remote controller as Cooling Only,
then you CAN NOT preset the Heating operation with the remote controller.
Remote Controller presetting
Before using the air conditioner, be sure to check and preset the following.
Auto Restart Presetting
The remote controller is
presetting correctly for cooling and reverse cycle.
NOT
User can preset the remote controller type depending on the air conditioner type you have purchased
as follows:
Each time after replacing the batteries in the remote controller, the Cooling indicator
and
Heating indicator
will flashes alternately on LCD of the remote controller.
Press any button when
flashes, Heat Pump is set.
Press any button when
flashes, Cooling Only is set.
If you don't press any button within 12 seconds, the remote controller is preset to Heat Pump automatically.
If you want auto restart function, hold down the Emergencybutton (ON/OFF) on the indoor unit for over 5
seconds, auto restart function is set with a buzz sound, air conditioner is on standby.
If auto restart has been set, hold down the Emergency button (ON/OFF) on the indoor unit for over 5
seconds, auto restart function is canceled with buzz sound, air conditioner is on standby.
PDF created with pdfFactory Pro trial versi