NordicTrack CX 1055 elliptical exerciser 30508.0 - Manual (Page 5)

5
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the two
included hex keys, assembly requires a phillips screwdriver , two adjustable
wrenches , a rubber mallet , and pliers .
Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each
drawing is the key number of the part, from the PART LIST on page 25. The number following the key number is
the quantity needed for assembly.
Note: Some small parts may have been pre-assembled. If a part is not in
the parts bag, check to see if it has been pre-assembled.
M8 x 68mm Button Screw (110)–8
M8 x 76mm Button Bolt (112)–4 M8 x 23mm Flat
Head Screw (88)–6
M8 Split
Washer
(101)–12
M8 x 28mm
Washer (99)–4
M8 x 25mm
Washer (95)–2
M8 Washer
(94)–6
Wave Washer
(100)–2
M8 Nylon
Locknut (102)–12
M8 x 20mm Button
Screw (113)–2
M8 x 25mm Button
Screw (81)–2
M4 x 25mm
Screw (105)–4
M8 x 56mm Button Screw (108)–4