NordicTrack NTCW90907.0 - Manual (Page 13)

13
HOW TO USE THE ELLIPTICAL EXERCISER
HOW TO PLUG IN THE POWER SUPPLY
Plug one end of the included power supply into the
jack on the front of the elliptical exerciser. Plug the
other end of the power supply into an appropriate out-
let that is properly installed in accordance with all local
codes and ordinances.
HOW TO MOVE THE ELLIPTICAL EXERCISER
Due to the size and weight of the elliptical
exerciser, moving it requires two persons. Stand in
front of the elliptical exerciser, hold the upright, and
place one foot against one of the front wheels. Pull on
the upright and have a second person lift the frame
until the elliptical exerciser will roll on the front wheels.
Carefully move the elliptical exerciser to the desired
location, and then lower it to the floor.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
If the elliptical exer-
ciser rocks slightly
on your floor during
use, turn one or
both of the leveling
feet beneath the
front and rear of the
frame until the rock-
ing motion is
eliminated.
HOW TO ADJUST THE STRIDE OF THE
ELLIPTICAL EXERCISER
To adjust the stride of the elliptical exerciser, turn the
adjustment knob clockwise while pulling it outward
until the adjustment arm pivots freely. Pivot the adjust-
ment arm until the adjustment knob is aligned with one
of the holes in the handlebar leg, and gently release
the knob. Then, pivot the adjustment arm back and
forth slightly to make sure that the adjustment pin is
engaged in one of the holes in the handlebar leg.
Adjust the other side of the elliptical exerciser in
the same way.
Place
your foot
here
Pull on
upright
Leveling
Foot
Lift here
Adjustment
Arm
Adjustment
Knob
Handlebar
Leg
Adjustment
Pin
Holes