Warning, Important precautions – NordicTrack 4200 R User Manual
Page 3
PART LIST—Model No. NETL92130
R0703A
To locate the parts listed below, see the EXPLODED DRAWING attached in the centre of this manual.
Key No. Qty.
Description
Key No. Qty.
Description
1
1
Allen Wrench
2
2
Rear Wheel Bolt
3
1
Rear Endcap (Left)
4
2
Roller Star Washer
5
2
Rear Roller Adj. Bolt
6
2
Rear Wheel
7
4
U-nut
8
8
Endcap Bolt
9
1
Roller Guard (Left)
10
1
Roller Guard (Right)
11
1
Rear Endcap (Right)
12
8
Endcap Nut
13
8
Endcap Washer
14
1
Rear Roller
15
1
Warning Decal
16
2
Foot Rail Cover
17
1
Pulse Receiver
18
2
Belt Guide
19
1
Choke
20
2
Frame Pivot Bolt
21
2
Frame Pivot Washer
22
1
Left Foot Rail
23
1
Walking Belt
24
1
Walking Platform
25
1
Right Foot Rail
26
1
Front Endcap (Left)
27
1
Ground Wire
28
4
Support Bracket Screw
29
1
Support Bracket
30
1
Front Roller/Pulley
31
1
Magnet
32
1
Motor Belt
33
1
Motor
34
2
Frame Pivot Bushing
35
2
Frame Pivot Spacer
36
1
Reed Switch Clip
37
1
Reed Switch
38*
1
Idler Assembly
39
1
Idler Pulley Bolt
40
1
Pulley Bushing
41
1
Idler Pulley
42
8
Lift Motor Nut/Idler Nut
43
4
Tension Washer
44
2
Incline Motor Bolt (Top)
45
1
Idler Arm Bearing
46
1
Idler Arm
47
1
Idler Spring
48
9
Hood Mount Screw
49
5
Hood Mount
50
1
Incline Motor
51
1
Incline Motor Bolt (Bottom)
52
1
Incline Motor Bracket
53
1
Front Roller Adj. Bolt
54
1
Front Roller Nut
55
2
Motor Bolt
56
1
Pulse Wire
57
1
Lift Leg
58
1
Left Fan Housing
59
2
Large Cage Nut
60
2
Plastic Stand-off
61
1
Front Endcap (Right)
62
1
Motor Hood
63
2
Hood Clip
64
1
Controller
65
1
Controller Bracket
66
1
Motor Controller Wire
67
2
Euro Power Cord
68
1
Receptical
69
1
Circuit Breaker
70
1
12” Audio Wire
71
1
Audio Wire Nut
72
1
On/Off Switch
73
2
Static Decal
74
1
Belly Pan
75
4
Tie Holder
76
1
Belly Pan Bracket
77
2
Support Bracket Screw
78
1
Filter Wire
79
1
Console Ground Wire
80
1
Console Base
81
1
Console
82
1
Book Holder
83
1
Handrail
84
2
Handrail Endcap
85
1
Hand Grip Pulse
86
21
Screw
87
26
Console Screw
88
4
2” Console Screw
89
1
Console Back
90
1
Base Plate Bumper
91
1
Base Plate
92
3
Base Plate Screw
93
9
Base Screw
94
1
Wire Track
95
4
Base Pad
96
3
Cage Nut
97
2
Upright Endcap
98
1
Key/Clip
99
1
Upright
100
2
Front Wheel Bolt
34
1. It is the responsibility of the owner to ensure
that all users of this treadmill are adequately
informed of all warnings and precautions.
2. Use the treadmill only as described in this
manual.
3. Place the treadmill on a level surface, with at
least 2.5 m (8 ft.) of clearance behind it and
0.5 m (2 ft.) on each side. Do not place the
treadmill on any surface that blocks air open-
ings. To protect the floor or carpet from dam-
age, place a mat under the treadmill.
4. Keep the treadmill indoors, away from mois-
ture and dust. Do not put the treadmill in a
garage or covered patio or near water.
5. Do not operate the treadmill where aerosol
products are used or where oxygen is being
administered.
6. Keep children under the age of 12 and pets
away from the treadmill at all times.
7. The treadmill should not be used by persons
weighing more than 135 kg (300 lbs.).
8. Never allow more than one person on the
treadmill at a time.
9. Wear appropriate exercise clothes when
using the treadmill. Do not wear loose clothes
that could become caught in the treadmill.
Athletic support clothes are recommended for
both men and women. Always wear athletic
shoes. Never use the treadmill with bare feet,
wearing only stockings, or in sandals.
10. When connecting the power cord (see page 9),
plug the power cord into an earthed circuit. No
other appliance should be on the same circuit.
When replacing the fuse, an ASTA approved
BS1362 type should be fitted to the fuse car-
rier. A 13 amp fuse should be used.
11. If an extension cord is needed, use only a 3-
conductor, 1mm
2
(14-gauge) cord that is no
longer than 1.5 m (5 ft.).
12. Keep the power cord away from heated sur-
faces.
13. Never move the walking belt whilst the power
is turned off. Do not operate the treadmill if
the power cord or plug is damaged, or if the
treadmill is not working properly. (See
BEFORE YOU BEGIN on page 5 if the tread-
mill is not working properly.)
14. Never start the treadmill whilst you are stand-
ing on the walking belt. Always hold the
handrails whilst using the treadmill.
15. The treadmill is capable of high speeds.
Adjust the speed in small increments to avoid
sudden jumps in speed.
16. The pulse sensors are not medical devices.
Various factors, including the user's move-
ment, may affect the accuracy of heart rate
readings. The pulse sensors are intended
only as exercise aids in determining heart
rate trends in general.
17. Never leave the treadmill unattended whilst it
is running. Always remove the key, unplug
the power cord and move the on/off switch to
the off position when the treadmill is not in
use. (See the drawing on page 5 for the loca-
tion of the on/off switch.)
18. Do not attempt to raise, lower, or move the
treadmill until it is properly assembled. (See
ASSEMBLY on page 6, and HOW TO FOLD
AND MOVE THE TREADMILL on page 25.) You
must be able to safely lift 20 kg (45 lbs.) in
order to raise, lower, or move the treadmill.
19. Do not change the incline of the treadmill by
placing objects under the treadmill.
20. When folding or moving the treadmill, make
sure that the storage latch is fully closed.
21. When using iFIT.com CDs and videos, an
electronic “chirping” sound will alert you
when the speed and/or incline of the treadmill
is about to change. Always listen for the
“chirp” and be prepared for speed and/or in-
cline changes. In some instances, the speed
and/or incline may change before the per-
sonal trainer describes the change.
WARNING:
To reduce the risk of burns, fire, electric shock, or injury to persons, read the
following important precautions and information before operating the treadmill.
IMPORTANT PRECAUTIONS
3