NordicTrack ViewPoint NTL11806.0 - Manual (Page 24)

24
HOW TO OPERATE THE PERSONAL TELEVISION
IMPORTANT: Before operating the television, you
must connect an antenna, a 75 ohm CATV cable, or
a VCR to the 75 ohm antenna terminal on the tread-
mill; a VCR or a DVD player to the three audio/video
RCA jacks; or a personal audio/video player to the
audio/video plug below the television on the con-
sole. See page 13 for instructions.
Follow the steps below to operate the television.
Insert the key into the console.
See HOW TO TURN ON THE POWER on page
16.
Press the Power button to turn on the
television, and press the AV button to select a
television source.
Press the Power button repeatedly until the word
TUNER appears on the screen. Next, select a
television source by pressing the AV button re-
peatedly. If you have connected an antenna, a 75
ohm CATV cable, or a VCR to the 75 ohm antenna
terminal on the treadmill, press the AV button until
the word TUNER appears on the screen. If you
have plugged a DVD player or a VCR into the
three audio/video RCA jacks, press the AV button
until the words INPUT 1 appear. If you have con-
nected a personal audio/video player to the
audio/video plug below the television on the con-
sole, press the AV button until the word MP3 ap-
pears. Note: To turn off the television, press the
Power button until the word CONSOLE appears.
Press the Channel buttons to select the
desired channel.
When the television is turned on, the screen will
show the last channel that was selected. To select
a different channel, press the Channel (CH.) but-
tons. The selected channel number will appear on
the screen for a few seconds. Note: The television
is equipped with a channel memorizing function
that allows you to go directly from the current
channel to the next channel saved in memory.
Before channels can be selected in this way, they
must be saved in the television’s memory. See
HOW TO USE THE INFORMATION MODE on
page 25.
Press the Volume buttons to adjust the volume.
When either Volume (VOL.) button is pressed, the
volume level indicator will appear on the screen
for a few seconds.
To use earphones or headphones (not included),
plug them into the headphone jack below the key
on the console.
HOW TO USE THE STEREO SOUND SYSTEM
To play music or audio books through the console’s
stereo speakers, you must connect your MP3 player,
CD player, or personal audio/video player to the con-
sole. Locate the audio/video plug below the television
on the console, and plug it into a jack on your MP3
player, CD player, or personal audio/video player.
Make sure that the audio/video cable is fully
plugged in.
Next, press the Play button on your MP3 player, CD
player, or personal audio/video player. Then, adjust
the volume on your MP3 player, CD player, or per-
sonal audio/video player. You can also adjust the vol-
ume on the console by pressing the Volume increase
and decrease buttons.
If you are using a personal CD player or a DVD player
and the CD or DVD skips, set the CD player or DVD
player on the floor or another flat surface instead of on
the console.
4
3
2
1