NEC AccuSync LCD224WXM - Manual (Page 8)

6
Quick Start
- continued
Tighten all
screws.
4 SCREWS (M4)
(MAX depth: 10.0 mm)
Thickness of Bracket
(Arm) 2.0~3.2 mm
100 mm
12mm
4 x 12mm with lock washer
and fl at washer
M4
If using other screws,
check depth of holes.
100 mm
Weight of LCD assembly:
LCD174WXM : 3.4 kg (MAX)
LCD194WXM : 4.3 kg (MAX)
LCD224WXM : 4.8 kg (MAX)
Removing the Base
Note: Always remove the Base when
shipping the LCD.
1. Place monitor face down on a
non-abrasive
surface.
2. Using your fi ngers, press the
3 release tabs on left or right side at
the same time to unlock the Base.
3. Using your fi ngers, press the 3 release tabs on the
other side at the same time to unlock the Base.
4. Pull out the unlocked Base.
Connecting a Flexible Arm
This LCD monitor is designed for use with a fl exible arm. Please use the attached
screws (4pcs) as shown in the picture when installing.
To meet the safety requirements, the monitor must be mounted to an arm which
guaranties the necessary stability under consideration of the weight of the monitor.
The LCD monitor should only be used with an approved arm (e.g. GS mark).
NOTE: The mounting stand must be able to sustain at least 15kg (LCD174WXM),
19kg (LCD194WXM), 21kg (LCD224WXM) and be UL certifi ed.
Release Tab