Nokia FPS-8 - Manual (Page 20)

20 (30)
7.3.1.1 Memory module installation instructions
NOTE!
When opening the prommer box or installing power / memory modules all
work should be done in an ESD – safe environment!
Step1: power off FPS-8. FPS-8 has to be powered off when mounting memory modules or DCT-3
power supply ACS-10 module. Mounting modules with power supply connected may cause permanent
damages!
Step2: open four crosshead screws (Phillips screws) from rear side of the FPS-8 box.
Step3: carefully remove rear panel (Pic 13 FPS-8 rear panel) and the cover .
Step4: take out SF12 or SF13 from the package (Pic 21 SRAM & FLASH memory sales packages)
and attach it to (Pic 17 Memory extension connector) memory extension connector. Make sure that
memory card screw holes are positioned along with screws on the board correctly (Pic 18 Mounting
memory module). Press directly downwards as far as memory card can go. Make sure that memory
card connector is attached properly with main board memory extension connector!
Step5: Take two plastic screws that came along the add-on memory package and drive them in to the
two other screws.
Step6: put cover and rear panel back and close four crosshead screws (Phillips screws)
Pic 17 Memory extension connector