R- 6l r- 8l, Problem, Solution – Niles Audio Niles R-6 L User Manual

Page 2: Hand-held learning remote control

Advertising
background image

CO

conFIGurAtIon cont.

NOTE: IF THE SOURCE KEY LED DISPLAYS ONE LONg FLASH

INSTEAD, YOUR bATTERIES ARE LOW, OR THE HAND-HELD

LEARNINg REMOTE CONTROL HAS NO FREE MEMORY

SPACE AVAILAbLE. IN EITHER CASE, THE REMOTE CANNOT

LEARN A NEW KEY. REPLACE THE bATTERIES IF NECESSARY,

OR IN THE CASE OF MEMORY SPACE SHORTAgE DELETE

CODES TO FREE SPACE.

4. Press the key on the Niles R-6L or R-8L

hand-held Learning Remote Control you
wish to learn. The source key LED will blink
rapidly for three seconds, indicating the
remote is ready to learn.

c

5. On the original remote, press and hold the

key to be learned. Continue holding the key
on the original remote until the R-6L or R-8L

con

hand-held Learning Remote Control source
Key LED blinks twice.

NOTE: IF THE SOURCE KEY LED DISPLAYS ONE LONg

bLINK, A LEARNINg ERROR HAS OCCURRED. TRY

REPEATINg THIS STEP AgAIN UNTIL A SUCCESSFUL

CAPTURE IS ObTAINED. IF THE FUNCTION IS STILL

NOT CAPTURED, PRESS AND HOLD SETUP TO

ExIT PROgRAMMINg AND REVIEW THE “LEARNINg

PRECAUTIONS” AbOVE. IF NEEDED, ALSO SEE

“TROUbLESHOOTINg”. AFTER REVIEW, START

PROgRAMMINg AgAIN AT STEP 1.

6. Repeat steps 4 through 5 for another key

you would like to learn. Once you have
completed learning all keys, press and hold
seTup
until the source key LED blinks twice
to save all data learned.

deLetInG A SInGLe LeArned Key
This process returns the key to its original

programming for the device you select. You can

also delete learned programming by teaching a

different function to the key (see “

programming a

Learned Key”).

Note: if more thaN 10 secoNds Pass

betweeN key Presses, the remote exits

ProgrammiNg mode.

1. Press the source key from which you wish

to remove the learned key

2. Press and hold seTup until the source key

LED blinks twice, then release

3. Enter 9 7 6. The source key LED blinks twice
4. Press the key containing the learned

function to be deleted twice. The source key

LED blinks twice and the remote exits from

programming mode

deLetInG ALL LeArned KeyS oF A

SpecIFIc deVIce

NOTE: IF MORE THAN 10 SECONDS PASS bETWEEN KEY

PRESSES, THE REMOTE ExITS PROgRAMMINg.

1. Press and hold seTup until the source key

LED blinks twice, then release

2. Press 9 7 6. The source key LED blinks twice
3. Press a source key twice to clear all the

learned keys for that device. The source key

LED blinks twice and the remote exits from
programming mode

reStorInG Key FunctIonS to

FActory SettInGS

1. Press and hold seTup until a source key

LED blinks twice, then release.

2. Enter 9 8 0. A source key LED blinks twice.
3. Press and hold seTup until a source key

LED blinks twice, then release.

proGrAMMInG SequenceS
Your Niles

R-6L/R-8L Hand-Held Learning

Remote Control includes the ability to program any
key (other than the

setup key) with a Sequence

of functions. Each key can be set up to perform a
pre-programmed set of sequential commands with
the press of one key. A sequence can be used to
control a home theater operation, to set a favorite
channel, or for other multiple functions you would
like to control with one key press. Moreover, each
Sequence Key can hold up to 15 commands.

Note: ProgrammiNg a New sequeNce over aN

existiNg oNe erases the origiNaL sequeNce.

troubLeSHootInG

pRobLem:

1. LeD does not blink when you press a key.

soLutIoN:

• Try pressing different keys. Replace the

batteries with 2 new AA batteries

pRobLem:

2. LeD blinks when you press a key, but

device does not respond.

soLutIoN:

• Make sure the remote is aimed at your

device and is not more than 40 feet away

pRobLem:

3. source key LeD blinks one long blink

while in setup mode.

soLutIoN:

• An entry error has occurred (for example,

wrong key). Try entering the sequence again

pRobLem:

4. Remote does not control devices or

commands are not working properly.

soLutIoN:

• Try all listed codes for the device. Make

sure the device operates with an infrared

remote control

pRobLem:

4. CH+, CH-, and LAst do not work for your

RCA tV.

soLutIoN:

• Due to RCA design from 1983 to 1987, only

the original remote control will operate

these functions

pRobLem:

5. Channels do not change properly when

directly entering digits to change

channels.

soLutIoN:

• If the original remote control required you

to press Enter to change channels, press

Enter on this remote after entering the

channel number

proGrAMMInG A deVIce

dependent Sequence

1. Press a source key.
2. Press and hold seTup until the source key

LED blinks twice, then release.

3. Press 9 7 8. The source key LED blinks twice.
4. Press the key to which you wish to assign

a sequence.

5. Enter the series of commands (key presses)

you want the sequence to execute (up to

15 commands).

6. Press and hold seTup until the source key

LED blinks twice, then release.

Now, when you press the sequence key , the
remote sends the series of commands you have
entered, but only if the device selected in

step

1 Is active. For example, you could program the
sequence key to turn on both your TV and cable
box and select a particular channel, but only if the
TV is selected. If the DVD is selected, this key does
not execute the sequence you set up for the TV. To
clear the sequence, repeat

steps 1-6 above, but do

not enter a series of commands at

step 5.

r-6L r-8L

I N S T A L L A T I O N & O P E R A T I O N G U I D E

B

l e n d i n g

H

i g H

F

i d e l i t y

A

n d

A

r c H i t e c t u r e

®

N i l e s A u d i o C o r p o r a t i o n

1 2 3 3 1 S . W. 1 3 0 S t r e e t M i a m i , F l o r i d a 3 3 1 8 6

1 - 3 0 5 - 2 3 8 - 4 3 7 3

1 - 8 0 0 - b u y- H I F I – w w w. n i l e s a u d i o . c o m

©2008 Niles Audio Corporation. All rights reserved. Niles, the Niles
logos, MicroFlashers and Blending High Fidelity and Architecture are

registered trademarks of Niles Audio Corporation. All other trademarks

are the property of their respective owners. DS00622A

13

15

14

11

12

SpecIFIcAtIonS

transmitter: Infrared
signal Range: Approximately 15-30 Feet
(4-10 Meters)
power supply:
Two “AA” batteries
(1.5Vx2)

LIMIted WArrAnty

Niles Audio Corporation (“NILES”) warrants to the original retail

purchaser only that this product will be free of manufacturing

defects in material and workmanship for the following periods

and subject to the limitations and exclusions set forth below:

Lifetime Warranty

All Passive Loudspeaker Products (those not requiring AC

or battery power).

Ten years from the date of purchase

All Other Passive Products (those not requiring AC or

battery power).

Two years from the date of purchase

All Active Products (those requiring AC or battery power).

This warranty is not transferable to subsequent purchasers

of the product. To obtain warranty service, contact the

authorized dealer where you purchased your product or take

the unit to the nearest authorized NILES dealer (with proof

of purchase – claims made without proof of purchase will be

denied) who will test the product and if necessary, forward it

to NILES for service. If there are no authorized NILES dealers

in your area, you must contact NILES to receive a factory

Return Authorization Number. DO NOT RETURN ANY UNIT

WITHOUT FIRST RECEIVING WRITTEN AUTHORIZATION AND

SHIPPING INSTRUCTIONS FROM NILES.

Upon examination, NILES will, at its sole option and expense,

repair or replace any product found to be defective. NILES

will return the repaired or replaced unit to you via its usual

shipping method from the factory to your address in the United

States of America or Canada only. Any shipping costs for

addresses outside of the United States or Canada shall be the

responsibility of the purchaser. In the event that this model is

no longer available and cannot be repaired effectively, NILES,

at its sole option, may replace it with a different model of equal

or greater value, or refund the original purchase price paid.

THE FOREGOING ARE YOUR EXCLUSIVE REMEDIES FOR

BREACH OF WARRANTY.

This Warranty does not include service or parts to repair

damage caused by improper use or handling, including but not

limited to damage caused by accident, mishandling, improper

installation, commercial use, abuse, negligence, or normal

wear and tear, or any defect caused by repair to the product

by anyone other than NILES.

This warranty does not cover reimbursement for your costs

of removing and transporting the product for warranty service

evaluation, or installation of any replacement product provided

under this warranty.

hand-held learning remote control

17

16

This Warranty will be void if:

• The Serial Number on the product has been removed,

tampered with or defaced.

• The product was not purchased from an authorized

dealer or reseller.

THE FOREGOING WARRANTIES ARE EXCLUSIVE AND

IN LIEU OF ALL OTHER EXPRESSED AND IMPLIED

WARRANTIES. NILES EXPRESSLY DISCLAIMS ALL SUCH

OTHER WARRANTIES, INCLUDING BUT NOT LIMITED

TO IMPLIED WARRANTIES OF MERCHANTABILITY,

FITNESS FOR A PARTICULAR PURPOSE AND NON-

INFRINGEMENT, WITH RESPECT TO THE PRODUCT. TO

THE MAXIMUM EXTENT PERMITTED BY LAW, NILES

SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL OR

CONSEQUENTIAL DAMAGES EXCEPT TO THE EXTENT

PROVIDED (OR PROHIBITED) BY APPLICABLE LAW, EVEN

IF NILES HAS BEEN ADVISED OF THE POSSIBILITY OF

SUCH DAMAGES.

Notwithstanding the above, if you qualify as a “consumer”

under the Magnuson-Moss Warranty Act, or applicable state

laws, then you may be entitled to any implied warranties

allowed by law for the Warranty Period. Further, some states

do not allow limitations on how long an implied warranty lasts

or allow the exclusion or limitation of consequential damages,

so such limitations may not apply to you. This warranty gives

you specific legal rights, and you may also have other rights

which vary from state to state.

For the name of your nearest authorized NILES dealer,

contact: NILES AUDIO CORPORATION, P.O. BOX 160818,

Miami, Florida 33116-0818, or call 1-800-289-4434, 1-

305-238-4373. Please be advised that NILES only sells its

products via the Internet through a select group of authorized

Internet dealers. These are listed on our website at www.

nilesaudio.com. Products offered on the Internet through

unauthorized Internet dealers are not covered by the NILES

warranty and may be either:

1) goods acquired on a secondary or grey market

2) counterfeit or stolen goods

3) damaged, or defective goods

ATTENTION: TO OUR VALUED CONSUMERS:

To insure that consumers obtain quality pre-sale and after-sale

support and service, NILES products are sold exclusively

through authorized dealers. This warranty is VOID if the

products have been purchased from an unauthorized dealer

.

18

DS00622A-2 R-6L_R-8L Remote.indd 2

4/7/08 3:40:20 PM

Advertising
This manual is related to the following products: