Nextar NC990C - Manual (Page 8)

17. INFRARED REMOTE CONTROL SENSOR
18. EJECT BUTTON
Press this key, a loaded disc can be to ejected.
19. CLOCK BUTTON
Press the CLK button briefly to display time for 5 seconds on the display, and then
returns to its previous display unless the button is pressed again.
Then press the CLK button and hold for more than 1 seconds until the real time
flashes on the display. Then you can adjust HOUR or MINUTE by rotating the
VOL knob.
20. SCAN BUTTON
Press it to scan up by one channel step with station detection. If a valid signal has
detected, the current frequency is blinked within 5 seconds, then press it again to
stop scan and remain the current frequency; otherwise, the unit continue to scan up
by one channel step with station detection 5 seconds later.
21. RESET BUTTON
Before operating the unit for the first time, or after replacing the car battery or
changing the connections. You must reset the unit.
Press this button with a cuspidal object. This operation will erase the clock setting
and some stored contents.
E 7