Navigon Fujitsu Siemens Pocket LOOX N100 - Manual (Page 86)

User Manual MobileNavigator 6
- 84 - Basic settings
Map 2D:
Orientation
Establish how the map should be aligned as
standard when navigating in 2D view.
in direction of travel: The direction in which
you are driving is above. This view is
very suitable for navigation.
set to north: North is up. This alignment
corresponds to a printed map. It is
suitable in order to get an overview of a
specific area.
The factory default is in direction of travel.
Show altitude and
speed
Establish if the current altitude above sea
level and the current speed should (Yes) or
shouldn't (No) be shown on the map.
The factory default is No.
Show remaining
distance
Establish whether the remaining distance to
the destination, and, if stages are planned
in, also the remaining distance to the next
route point should (Yes) or shouldn't (No)
be shown on the map.
The factory default is Yes.
Show duration of
journey
Establish whether the remaining duration of
drive to the next destination, and, if stages
are planned in, also the remaining duration
until the next route point, should (Yes) or
shouldn't (No) be shown on the map.
The factory default is No.
Show time of
arrival
Establish whether the probable arrival time
to the next destination, and, if stages are
planned in, also the probable arrival time
until the next route point, should (Yes) or
shouldn't (No) be shown on the map.
The factory default is Yes.
Info when crossing
borders
Establish if, when crossing a border,
information should (Show) or shouldn't
(Hide) be shown regarding the now valid
speed restrictions.
The factory default is Show.
Show signposts
Establish, whether during a navigation the
signposts that you must follow should (Yes)
or shouldn't (No) be shown.
The factory default is Yes.
Note: This display depends on the
information being available in the map
material that is currently being used. This is
not always the case on all streets.