Niles Audio SVL-2 - Manual (Page 7)

near electrical devices, route the speaker wires several feet
away from the electrical wiring.
Using the SVL-2 with Tube-Type Amplifiers
Virtually all tube amplifiers must have a load connected at all
times. If the amplifier to be connected to the SVL-2 is a tube
amplifier, be sure to always have at least one pair of speakers
switched on at all times. An alternative is to permanently
connect a 150 ohm, 5 watt resistor across the tube amplifier's
output in parallel with the SVL-2. See (Figure 1) for hookup
diagram.
6
S
P E A K E R
S
E L E C T I O N
/ V
O L U M E
C
O N T R O L
S
Y S T E M
Figure 1
Using a
Tube Amplifier
150 150
SPEAKER 2 SPEAKER 1
L R
AMPLIFIER
L R L R
+ +
- -
+ +
- -
Niles Audio
Corporation, Inc.
Miami, Florida USA
NILES
Tube Amplifier
Niles SVL-2