National Instruments SHC68-H1X38 - Manual (Page 4)

Digital Flying Lead Cable User Guide 4 ni.com
Figure 2. Detailed Parts Locator Diagram for the Lead Pairs
Connecting Signals
Each DIO, PFI, and clock channel of the NI digital waveform
generator/analyzer connects to a corresponding pair of leads on the
NI SHC68-H1X38 cable.
The NI SHC68-H1X38 cable is separated into two bundles of 19 channels,
and each channel is split into a pair of leads for connecting the signal and
its associated ground. Table 1 describes the channels and shows how they
are grouped by bundle.
1 0.25 in. diameter 0.1 in. pitch
compatible receptacles
2 Strain-relief and label
3 Microcoaxial wire
4 Ground
Table 1. NI Digital Waveform Generator/Analyzer Signal Descriptions
Channel Signal Description Bundle
DIO <0..31> Bidirectional digital data channels 0
through 31. Refer to the documentation
for your NI digital waveform
generator/analyzer for information about
the number of available DIO channels on
your device. DIO <20..31> may not
apply to your device. DIO<0..15>: Bundle A
DIO<16..31>: Bundle B
STROBE / PFI 5 For devices that have a STROBE
channel, this signal is the external
Sample clock source for dynamic
acquisition. Otherwise, this is
programmable functional interface
(PFI) 5. Bundle A
1 2
3
4