Rear panel features – Numark Industries DM3001X User Manual
Page 8
DM3001X
- The Leader in DJ Technology
©2001
Industries
- 8 -
http://www.numark.com
REAR PANEL FEATURES
1
2
3
4
5
6
8
7
10
9
3
6
1.
Power Input - to plug your power plug in before switching on power. See safety precautions on page 3 for proper treatment of power.
2.
Voltage Selector – Set this to the appropriate power for your location. If unsure ask your authorized dealer.
3.
Phono Inputs – plug your turntables in here.
4.
Ground lug - use these connections with your turntables’ grounding cable to avoid signal hum.
5.
Stereo/Phono Selector –
select the appropriate position for your input device. With phono selected the input signal is fed directly
to the DM3001X phono pre-amplifiers so use this input only for turntables. Line level sources will overload the sensitive phono
pre-amps. Switch this over to the AUX position for line devices such as CD players and Tape decks.
6.
Line Inputs - to connect stereo audio from HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser discs, tuners,
even synthesizers or other mixing consoles.
NOTE: Plug mono audio sources into both Left and Right inputs using a “Y" cable connector.
7.
Channel PFL Send – this output contains the PFL signal you hear in your headphones. The send should be plugged into your sampler and
the signal returned through one of your inputs.
8.
Record Outputs – Plug in your tape deck to record your mix. Audio level is determined by the channel inputs.
9.
Zone Outputs – Plug in a sound system for another room or booth monitor.
10. Unbalanced Main Outputs – program output controlled by the Master fader knob.