Nokia 112T - Manual (Page 5)

GB 5
Connecting the Mediamaster
Front and Rear panel
TV aerial
for connection of the antenna.
Also, a Nokia active indoor antenna is
powered from this
connection *
DC in
for connecting the cable
from the external power
supply
TV SCART socket * *
for connection to the TV SCART
Slot
112 T = for a Viaccess smart card
120 T = for a Conax smart card
Digital audio
Digital audio output
(TOS-link optical
connection)
Connecting the Mediamaster
The box for your Mediamaster should contain the following items:
• the Mediamaster
• a remote control with 2 AAA batteries
• a SCART cable (fully connected; 1.0 m)
• an Introduction Guide
• a separate power supply
Preparing the remote control
• Remove the cover from the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA (1.5 V) batteries as shown in the diagram,
taking care to observe the + and - markings indicated inside.
• Replace the cover.
* * The TV SCART Socket
When you connect other devices to this socket, always use a fully
connected SCART cable like the one supplied. There are SCART
cables available that do not have all the pins connected,
which could reduce picture quality if you were to use them.
A constant green light indicates that the Mediamaster is
switched ON.
A constant red light indicates standby mode.
The light flashes red when commands from the remote control
are received.
The light flashes green during software updates.
Reset button
TV/VCR
For connecting to the
RF socket on the TV,
or to a Video
recorder
SCART
cable
Power supply
* IMPORTANT. PLEASE SEE INFORMATION
ON PAGE 9 ON HOW TO SWITCH OFF THE
ANTENNA POWER.