Network Technologies MAN009 - Manual (Page 3)

2
Setup
When using the USB-ADB adapter to connect to an NTI KVM switch:
1. Connect the male 8 pin minDIN end of the MKTINT-xx-MM cable to a female 8 pin minDIN Keyboard and Mouse input port on the
NTI KVM switch being used (see Fig. 3). Switch the power ON to the KVM switch if it isn't already.
2. Connect the male 4 pin miniDIN end of the MKTINT-xx-MM cable to either of the 4 pin miniDIN female ports on the USB-ADB
adapter (see Fig. 4).
3. Connect the USB type B male connector of the USB-AB-0.5M-5T cable (see Fig. 6) to the USB type B female port on the USB-
ADB adapter.
4. Connect the USB type A male connector of the USB-AB-0.5M-5T cable (see Fig. 7) to a USB type A female port on the host
computer. Note: It is important to make this connection last, particularly if the host computer is already ON at the t ime of
connection.
When using the USB-ADB adapter to connect an ADB MAC Keyboard and/or Mouse to a MAC with a USB port:
1. Connect the 4 pin minDIN male connector of the MAC keyboard and mouse assembly into either of the female 4 pin miniDIN ports
on the USB-ADB adapter.
2. Continue with steps 3 and 4 above.
PLEASE NOTE: We recommend that the host computer be configured such that the Sleep Mode is not enabled. However,
if it is necessary to enable the sleep mode, in order to wake up from Sleep Mode, the user must momentarily disconnect the
USB cable connection from either the USB-ADB adapter or from the host computer. Simply unplug the connection, then
plug it back in
.
Mating Face of a 4 pin miniDIN Female
USB Type A Male
Connector
USB Type B Male
Connector
Fig. 3 Fig. 4
Fig. 6
Fig. 7
Mating Face of a 8 Pin miniDIN Female