Numark Industries Professional Karaoke Mixing Station KMX02 User Manual

Page 3

Advertising
background image

3

REAR CONNECTIONS




1. Channel Inputs: Unbalanced RCA jacks

for connecting external sources. The

Phono/Line input is selected using the

toggle switch on the front panel.

Turntables, HiFi VCRs, cassette and reel-

to-reel tape decks, DAT machines, CD

players, laser discs, tuners, even

synthesizers or other mixing consoles

can be connected using these jacks.

NOTE: Plug mono audio sources into

both left and right inputs using a “Y”

cable connector.

2. GND: This screw connector should be

used to connect any turntables or other

devices that need to be grounded.

3. Input Selector Switch: Use this to

allow either line level or phono level

equipment to be plugged into your

channel inputs. When Phono input is

selected, your signal is fed directly to the

high-quality RIAA phono pre-amplifiers.

Use this position only for turntables. Line

level sources will overload the sensitive

phono pre-amps and will sound very

bad, so always be sure to toggle the

line/phono switch over to line before

connection of line sources.

4. Video OUTPUT: There are two outputs

that are connected to television monitors

to output karaoke text.

5. Master Output (RCA): This output is

for connecting an external monitoring

device such as a PA system, powered

monitors, or a home stereo. The level of

the master stereo output signal is

controlled by the master fader.

6. Stereo Balanced Master Outputs

(XLR): low-impedance XLR type

connectors controlled by the Master

fader.

7. Microphone 2 and 3 Input: Plug in

your ¼” microphones into 2 and 3.

These inputs have effects available on

the face panel.

8. AC In: This mix station is designed to

work with the power supply cord that

comes with the unit. While the power is

switched off, plug the power supply into

the mix station first, then plug it into the

outlet.

9. Power Switch: Use this switch to turn

on the mix station after all input devices

are already connected to prevent

damage to your equipment. Turn the

station on before you turn on amplifiers

and turn off amplifiers before you turn

off the mix station.

10. NTSC/PAL Switch: Selects the video

output between NTSC and PAL video

modes. NTSC is used in the United

States, while PAL is used in much of

Europe.




Advertising