Nortel Networks 2500 Series - Manual (Page 17)

NNCLI concepts 17
Key combination Function
Tab Command or parameter completion
Ctrl+K and Ctrl+R Redisplay line
Ctrl+N or Down arrow Next history command
Ctrl+P or Up arrow Previous history command
Ctrl+T Transpose characters
Ctrl+U Delete entire line
Ctrl+W Delete word to left of cursor
Ctrl+X Delete all characters to left of cursor
Ctrl+z Exit Global Configuration mode to Privileged Executive mode
? Context sensitive help
Esc+C and Exc+U Capitalize character at cursor
Esc+l Change character at cursor to lower case
Esc+B Move back 1 word
Esc+D Delete 1 word to the right
Esc+F Move 1 word forward
NNCLI access procedures
Perform the procedures in this section to access NNCLI.
Access prerequisites
• Connect to the switch with a console cable, connected directly to the
console port, or use Telnet.
•
If you connect to the switch remotely, through Telnet, ensure that you
enable remote access and that the switch IP address is valid.
• Use a terminal or a PC, with a terminal emulator, as the NNCLI
command station.
•
If you use a console cable and console port, ensure that the terminal
emulation program conforms to the settings in the following table.
Property Value
Baud Rate 9600 bps
Data Bits 8
Stop Bits 1
Parity None
Flow Control None
Terminal Protocol VT100 and VT100/ANSI
Nortel Ethernet Routing Switch 2500 Series
Fundamentals
NN47215-102 01.01 Standard
27 October 2008
Copyright © 2008 Nortel Networks
.