Nady Systems MXE-612 - Manual (Page 13)

SPECIFICATIONS
1. INPUT SECTION
2. OUTPUT SECTION
The specifications above are correct at the time of printing of this manual. For improvement purposes, all specifications
for this unit, including design and apperance, are subject to change without prior notice.
13
3. FREQUENCY RESPONSE
ANY INPUT TO
ANY OUTPUT ....................................... 20 Hz to 20 KHz =/- 3dB @ 0 dBm
4. TOTAL HARMONIC DISTORTION
ANY INPUT TO
ANY OUTPUT ................................. 0.02%, 20 Hz-20 KHz @ 1Khz, 0 dBm
5. INPUT CHANNEL EQUALIZATION
High shelving ....................................... 12 KHz, +/- 15 dB, Q fixed at 2 oct.
Mid bell ................................................ 2.5 KhZ, +/- 15 dB, Q fixed at 1 oct.
Low shelving .......................................... 80 Hz, +/- 15 dB, Q fixed at 2 oct.
6. GAIN CONTROL RANGE
Input channel trim control ...................... Stop to stop- Mic +10 dB~+60 dB,
Line +10 dB~+40 dB
Channel/Master/Effect Faders ................................................ - ∞ to +15 dB
Aux Send/Aux Master Send ................................................... Off to +15 dB
Aux Return ............................................................................. Off to +20 dB
Channel and Master Effect Sends ......................................... Off to +15 dB
7. CROSSTALK @ 1KHZ
ADJACENT CHANNEL INPUTS .......................................... -78 dB~-68 dB
INPUT TO OUTPUT ............................................................ -78 dB~-68 dB
Input Connector Input Impedance Nominal Level Max Level
8. HUM AND NOISE
20 Hz-20 KHz, Rs=150 ohms, input TRIM @ 0 dB, input sensitivity
at –60 dB
EQUIVALENT INPUT NOISE
-129 dBm
RESIDUAL OUTPUT NOISE
< 90 dBm
9. VU METERS
10-segment LED X 2
10. PHANTOM POWER
+48 VDC, globally selected
11. POWER REQUIREMENTS
Voltage selectable, 120VAC/60Hz or 230VAC/50Hz
12. POWER CONSUMPTION
12W
13. DIMENSIONS AND WEIGHT
9” x 7” x 2.5” (229 x 178 x 63.5 mm), 3.7 lbs (1.7 Kg)
MONO CH MIC XLR >1.3K
Ω
+2 dBm +14 dBm
MONO CH LINE 1/4” TRS >10K
Ω
+4 dBm +22 dBm
STEREO CH LINE 1/4” TRS >10K
Ω
+4 dBm +22 dBm
TAPE IN RCA PIN JACKS >10K Ω +2 dBm +22 dBm
AUX RETURNS 1/4” TRS >10K
Ω
+4 dBm +22 dBm
Output Connector Output Impedance Nominal Level Max Level
STEREO OUT L/R 1/4” TRS 120
Ω
+4~+6 dBm +22 dBm
AUX SENDS 1/4” TRS 120 Ω +4~+6 dBm +20 dBm
CTRL R OUT 1/4” TRS 120 Ω +4~+6 dBm +22 dBm
REC OUT RCA PIN JACKS 1K
Ω
+4~+6 dBm +22 dBm
PHONES 1/4” TRS 200K
Ω
—— 40mW X 2