Nokia 12 GSM MODULE REMOTE I/O - Manual (Page 12)

When you have completed the above steps, Configurator automatically
establishes a connection between the PC and the Nokia 12 GSM Module when
Configurator is started.
4.2 CONNECTING A DEVICE OR A MACHINE
Connect the device to be controlled with the Remote I/O control to the Nokia 12
GSM Module through the M2M system interface. The general-purpose inputs
and outputs of the M2M system connector that are described in Chapter 6 are
connected to the device.
More information about how to connect a device electrically to the Nokia 12
GSM Module and about the recommended connector types is provided in Nokia
12 GSM Module HW Integration Manual.
4.3 MANDATORY SETTINGS
To use the Remote I/O control of the Nokia 12 GSM Module, you have to
configure these settings:
• Message identifier
• SMS centre address
• You can also configure the following optional settings (described in Chapter
5):
• Disabling acknowledgements
• Security settings
• Input settings
• Defining aliases for text messages
• Initial output value settings
• GPS port settings
Use Nokia 12 Configurator to configure the settings of the Nokia 12 GSM
Module. Download Configurator at
http://www.forum.nokia.com or
http://www.americas.forum.nokia.com . You can also use a control message
(short message) for the optional settings.
The following sections describe the process of getting started with the Remote
I/O control.
Note: To use Configurator, you need the Nokia 12 GSM Module and a test board.
The Nokia 12 GSM Module is connected to a compatible PC and Configurator with
the test board. A power supply, data cable, antenna adapter, antenna, and SIM
card are also needed. All these items are included in the Nokia 12 GSM Module
test board sales package.
8/49