Installation procedures, Prepare the site, Install the hub – NETGEAR EN104TP User Manual

Page 6

Advertising
background image

Model EN104TP/EN106TP/EN108TP Ethernet Hub Installation Guide

Before you begin installing your hub, prepare the installation site. Make sure
your operating environment meets the operating environment requirements of
the equipment.

To install your hub on a flat surface, you do not need any special tools. Be sure the hub is
positioned with at least 2 inches of space on all sides for ventilation.

To install the hub on a wall, measure the distance between the mounting holes on the back of the
hub and mark the wall to match the location of the mounting holes on the hub. At the marked
location, screw into the wall the two screws that you received with the mounting kit included in
your package contents. B

e sure to choose a location that is near the devices to be

connected, is close to an electrical outlet, and provides at least 2 inches of space
all around the hub for ventilation.

Characteristic

Requirement

Temperature

Ambient temperature between 0

°

and 40

°

C (32

°

and 104

°

F).

No nearby heat sources such as direct sunlight, warm air
exhausts, or heaters.

Operating humidity

Maximum relative humidity of 90%, noncondensing.

Ventilation

Minimum 2 inches (5.08 cm) on all sides for cooling.
Adequate airflow in room or wiring closet.

Operating
conditions

At least 6 feet (1.83 m) to nearest source of electromagnetic
noise (such as photocopy machine or arc welder).

Service access

Minimum 12 inches (19.68 cm) front and back for service access
and maintenance.
Front and back clearance for cables and wiring hardware such as
punchdown blocks.

Power

Adequate power source within 6 feet (1.83 m).

Wiring hardware

Wiring hardware, such as punchdown blocks or patch panels,
should be complete before installing the hub.

Installation Procedures

Prepare the Site

Install the Hub

Advertising