Nvidia Quadro - Manual (Page 4)

2. Gently remove or open the systems enclosure (refer to owners manual that came with your
computer if necessary).
3. Perform the installation in a static safe environment and utilize a properly grounded anti-static
wristband. Place any static sensitive components in anti-static bags.
4. If a non-SLI capable graphics board occupies the x16 expansion slot, carefully remove it and
replace it with your SLI-capable graphics board.
5. Install the second SLI-capable graphics board in the adjacent slot, you may also need to
relocate a card and the chosen slot must be x16, x8 or x4 capable.
6. Connect the two graphics boards with the SLI bridge connector (used for SLI Frame Rendering
only).
7. If your graphics boards have an auxiliary power connector, connect them to the power supply
using the supplied power connector cables.
8. Replace the system’s cover and reconnect your display(s) to the SLI-capable graphics board
installed in the x16 expansion slot.
9. Plug the power cable back into the system
If you removed an existing graphics board, or any other PCI Express expansion boards during
this installation place them into antistatic bags/packaging for storage and safekeeping.
Display Driver Installation and Enabling SLI
Follow the steps listed below to install your driver software:
1. Power on the system and log into Windows.
2. Cancel the Windows “Found New Hardware Wizard” (you should see this window twice – one
for each graphics board) and run “setup.exe” in the SLI driver you saved to your desktop
previously to start the software installation process (if you open the zip file, you should see the
setup.exe file).
3. Follow the “Next” prompt to proceed with driver installation. You should see the message
“NVIDIA Quadro FX xxxx has not passed Windows Logo testing to verify its compatibility with
Windows XP.” This is because the SLI driver was not included on the Microsoft Windows XP CD.
Click “Continue Anyway” to proceed with driver installation. You should see this message a
second time because the SLI installer will detect the presence of the second graphics board and
install driver software for it as well. If this happens, click “Continue Anyway” a second time.
4. Once the software has been installed, choose “Yes, I want to restart my computer now” and
select “Finish” to reboot the system.
5. After logging back into Windows, you should see the message “SLI capable system” in the
bottom right corner of the screen as shown in Figure 3.
Figure 3.