NISSAN 2011 User Manual

Page 8

Advertising
background image

2011 NISSAN Towing Guide

7

Like ball mounts, hitch balls are available in a number of weight capacities and sizes. Always

make sure the hitch ball selected has the proper

shank diameter and weight rating for the ball

mount as well as the coupler on your trailer. Using a 1

7

/

8

” hitch ball in a 2” coupler, for example,

could result in the trailer separating from the tow vehicle.

The diameter of the hitch ball shank must be matched to the ball mount hole diameter. The

shank should be no more than

1

/

16

” smaller than the hole.

To keep the hitch ball in top condition, a simple maintenance routine is recommended.

Coating it with light grease will minimize wear of both the coupler and hitch ball. Also, by

removing the hitch ball when not towing, or by protecting it with a special cover, you will help

prevent rust from forming on it.

TRAILER TONGUE

The tongue is the part of the trailer that extends forward to meet the tow vehicle, and it also

carries the coupler assembly. Knowledge of the trailer minimum and maximum tongue load

(conventional trailers) and king pin load (5th wheel and gooseneck trailers) is critical as it can

have a significant effect on the handling of the tow vehicle. Refer to your vehicle owner’s

manual to view the maximum conventional trailer tongue load listed for your vehicle, and

always maintain no less than a minimum of 10 to 15% of the total load.

SAFETY CHAINS/CABLES

Always use suitable safety chains/cables

between the tow vehicle and the trailer. If

the hitch should break or become

disengaged for some reason, these

chains/cables will provide an emergency

connection between the vehicle and the

trailer.

The chains/cables should be crossed

under the trailer tongue and attached to the

hitch or vehicle frame. Crossing the

chains/cables under the tongue will help

prevent the tongue from hitting the ground

should the trailer become disconnected.

Be sure to leave enough slack in the

chains/cables to turn corners without

binding; however, note that excessive slack

Not OK

OK

Advertising