NordicTrack C 2300 NTL12943 - Manual (Page 7)

78 77
Thick
Side
Console
Assembly
69
77
118
4
7
5. With the help of a second person, carefully tip the
Uprights (69) down to the position shown. Make sure that
the Extension Legs (102) remain in the Uprights.
Attach each Extension Leg (102) with two 1” Tek Screws
(47) and a Base Pad (99) as shown. (Note: Attach the
lower Screw, without the Base Pad, first.) Next, align the
lower ends of the Handrails (118) with the holes in the
base of the Uprights (69). Attach each Handrail with a 4”
Bolt (53) as shown.
Note: The Bolts must be at an
angle that matches the angle of the Handrails as
shown in the inset drawing.
With the help of a second person, carefully tip the
Uprights (69) back to the vertical position. See step 4.
Tighten the four 4 1/2” Bolts (78).
Note: A replacement Base Pad (99) may be included. Use
the Base Pad to replace any Base Pad that becomes worn.
3. Cut the rubber band securing the Upright Wire Harness
(98). Have a second person hold the console assembly
near the Uprights (69). Connect the Upright Wire Harness
to the wires extending from the Console Base (81).
The
connectors should slide together easily and snap into
place. If they do not, turn one connector and try again.
Insert the connectors and the Upright Wire Harness down
into the right Upright, and then set the console assembly
on the Uprights.
Be careful not to pinch the wires.
98
69
81
Console
Assembly
3
98
118
53
4. Insert a Handrail (118) into the right side of the console
assembly as shown; you may need to twist the Handrail
as you insert it. Next, insert two 4 1/2” Bolts (78) with
Handrail Bushings (77) into the right Upright (69) and the
Handrail.
Be careful not to pinch the wires. Make sure
that the Handrail Bushings are flush against the right
Upright, with the thicker sides facing the center of the
treadmill, as shown in the inset drawing.
Next, lift the console assembly and the Handrail (118)
slightly and align the 4 1/2” Bolts (78) with the holes in the
Handrail. Thread the Bolts into the Upright (69) and the
Handrail until the heads of the Bolts are against the
Upright.
Do not tighten the Bolts yet.
Attach the other Handrail (not shown) in the same way.
Note: There are no wires on the left side.
47
53
53
99
99
102
118
69
99
47
102
99
99
99
5