Nokia 1209 - Manual (Page 4)

Get started
Insert the SIM card and battery
This device is intended for use with the BL-5CA battery.
Safe removal. Always switch the device off and disconnect the charger before removing
the battery.
1 Slide the back cover downwards (1), and remove it.
2 Lift the battery, and remove it (2).
3 Carefully lift the SIM card holder, using the finger grip of the device (3). Insert the
SIM card (4). Ensure that the contact surface area is facing down and the bevelled
corner of the SIM card is on the upper right side. Close the SIM card holder, and press
it to lock it into place (5).
4 Replace the battery and back cover (6, 7).
Charge the battery
Your battery has been partially charged at the factory. If the device indicates a low
charge, do the following:
1 Connect the charger to a wall outlet.
2 Connect the charger to the device.
3 When the device indicates a full charge, disconnect the charger from the device,
then from the wall outlet.
Tip: To save energy, unplug the charger when the battery is fully charged.
You do not need to charge the battery for a specific length of time, and you can use the
device while it is charging. If the battery is completely discharged, it may take several
4 Get started