NordicTrack NTEL12911 - Manual (Page 20)

20
Inspect and properly tighten all parts of the elliptical
crosstrainer regularly. Replace any worn parts immedi-
ately.
For smooth
operation of the
elliptical
crosstrainer, the
incline ramp
should be kept
clean. Using a
soft cloth and
mild detergent,
clean dust and
other residue
from the incline
ramp where the wheels make contact with it. Other
parts of the elliptical crosstrainer can also be cleaned
in this way. Keep liquids off the console. Never use
abrasives or solvents.
HOW TO LEVEL THE ELLIPTICAL CROSSTRAINER
If the elliptical
crosstrainer
rocks during
use, turn one or
both of the lev-
eling feet under
the rear stabiliz-
er until the rock-
ing motion is
eliminated.
HOW TO CALIBRATE THE RESISTANCE AND
INCLINE SYSTEMS
If the elliptical crosstrainer’s resistance system or
incline system is not working properly, activate the
calibration process by following the steps below.
1. Press the 10 Resistance button and the Start
Program button at the same time. The number 100
will appear in the right display.
2. Press the Start Program button again. “EP:2P” will
appear in the left display.
3. Press the 30° Ramp Angle button. The ramp will
move all of the way up and then all of the way
down. When this phase of the calibration process
is completed, the console will beep.
4. Press the 10 Resistance button. The letters CAL
will be displayed in the left display, and the lights
in the Training Zone bar will begin to flash. The
resistance motor will move the resistance to the
highest setting and then to the lowest setting.
When this phase of the calibration process is com-
pleted, the console will beep.
5. Press the Start Program button. A light test will
begin. Press the Start Program button again. The
light test will end and the calibration process will
be completed. The console will then be in the nor-
mal operating mode and the elliptical crosstrainer
will be ready for use.
MAINTENANCE AND TROUBLESHOOTING
Incline
Ramp
Wheel
Leveling
Feet