NEC Dterm Analog Cordless Telephone - Manual (Page 5)

4
Storing Mixed Tone/Pulse Numbers
If the telephone is set up for pulse dialing, mixed mode numbers can be stored to easily access
long distance services.
1. Remove the handset from the base unit.
2. Press memory. (The talk/battery low LED flashes and a beep is heard.)
3. Enter the number(s) to be dialed in pulse mode.
4. Press tone on the handset to enter a pause. (This also counts as one digit.)
5. Enter the number(s) to be dialed in tone mode.
6. Press memory and enter the memory location (0~9) you want to use.
The ability to pulse dial is dependent upon the telephone system and/or the outside lines to
which the D
term
Analog Cordless is connected.
Dialing a Stored Number
1. Remove the handset from the base unit.
2. Press talk.
3. Press memory and enter the memory location number (0~9) you want to dial. (If you select
a memory location that does not have a number stored in it, the handset beeps rapidly.)
4. The number is dialed.
Chain Dialing
After dialing a number you may be requested to enter a special access code, for example, when
performing a banking transaction.
To dial the number using chain dialing:
1. Remove the handset from the base unit.
2. Manually dial the telephone number.
3. Press memory and enter the memory location number (0~9) you want to dial.