NEC E1100+ - Manual (Page 14)

To attach the MultiSync E1100 monitor to your system, follow these
instructions:
1. Turn off the power to your computer and MultiSync monitor.
2. If necessary, install the display card. For more information,
refer to the display card manual.
3. For the PC: Connect the MultiSync E1100 monitor’s video
cable to the display card’s connector on the computer.
Tighten screws on all connectors.
For the Mac: Connect the MultiSync E1100 Macintosh
Cable Adapter to the monitor’s connector on your computer.
Connect the MultiSync E1100 monitor’s signal cable to the
other end of the cable adapter. Tighten screws on all
connectors.
4. Connect one end of the power cable to the MultiSync E1100
monitor and the other end to the power outlet.
5. Turn on your MultiSync monitor and computer.
6. This completes the installation.
NOTE: If you have any problems, please refer to the
Troubleshooting section of this manual.
Connection to Your Personal Computer E - 9