Hyundai H-LCD801 - Manual (Page 12)

12
Auto
Press CH+/CH- to select Auto adjust, press VOL+/VOL- can adjust the analog
quantity of bright, contrast, H.position, V.position, clock, phase etc. Screen will
display AUTO ADJUST ...... After seconds, auto adjust finish, the monitor has been
adjusted to the best state.
Reset
Press CH+/CH- to select RESET item, press VOL+/VOL- can set bright, contrast,
OSD V, OSD H, clock, color temperate etc of picture to factory default.
Clock
Can change the size of picture.
Sharpness
Adjust the edge sharpness in low resolution.
Blue back
Set blue back on/off under no signal.
OSD clock
Press CH+/CH- to select OSD clock, press VOL+/VOL- can adjust the time of OSD
menu display (5-100s).
Language:
Press CH+/CH- to select language, press VOL+/VOL- can realize the switch of
Russian and English OSD menu language.
Color Temp.(9300K,6500k)
Press CH+/CH- to select color temp, press VOL+/VOL- can realize the switch of
9300k, 6500k mode.
Display mode
Commendatory display mode: 640 x 480@60Hz
In order to receive clearer picture
Adjust the length, angle and direction of the telescopic antenna to obtain optimum
image. Draw back the antenna from the butt end after usage.
! Caution
In case the signal intensity is too weak, the image will remain inferior whatever you
adjust the antenna, and cause loud noise wave, shaking image and inferior sound, etc.,
which is not TV fault. If the image remains inferior when using telescopic antenna,
please try to use the external antenna or CATV.