Nuvo NV-T2FX - Manual (Page 30)

The song name displayed on my Display Pad does not match
what I'm hearing.
When I use Seek or Scan tuning, the tuner misses some
stations that I can receive in the manual, STEP tune mode.
There is a lot of hiss and extra noise on some of the AM
stations.
I want to have another audio source connected to the “AUX”
input, but I have no audio when I switch to that source.
The system will forward currently broadcasted Radio Data
Service (RDS) RadioText data from the station tuned.
Unfortunately, many stations do not keep this information
current in all cases.
Congratulations, your listening area is relatively free from
interference! You should lower the “seek threshold” by going
to MENU Adv. Settings Seek Threshold, selecting FM
Threshold, or AM Theshold as appropriate, and rotating the
SELECT knob counter clockwise. This will move the display
indicator toward LOW. Alternatively, you can do this in your T2
Configurator by going to the Config page, selecting View-
Advanced from the page menu, and dialing in the lower
threshold in the Seek/Scan Levels select box. This is found in
the “Tuning Parameters” section of the Windows page at the
lower right.
This is a common occurrence with some AM stations that have
a weaker signal. This can be minimized in the T2 Configurator
software by using the “High-Cut” feature in the Advanced
Preset settings. See “5.1 High Cut” on page 23 for detailed
instructions for using this feature.
Remember, you have to Enable the “AUX” input either at the
front panel through the advanced menu options, page 14, or in
the T2 Configurator software in the Advanced Config, page 23.
Page 29
Troubleshooting
Symptom Remedy