Nokia 3210 - Manual (Page 31)

CONFIDENTIAL Service & Analysis Center Europe
Training Team
version 1.0 / 05.11.1999 Page 31 of 37
Z701 faulty / poor soldering
• check the outgoing 13MHz IF on pin 30 N700 (SUMMA)
• check the input 13MHz IF on pin 25, 26 N700 (SUMMA) . The attenuation between input and output is ≈ 20dBm
• check the 13MHz IF on Z701, around 5dBm attenuation between signal-in and signal-out
• check the soldering of Z701 or change it
• check R717, R718, R719, C706 and the line resistance to ground (10K Ω with all components)
G700 UHF Oscillator faulty
• check the UHF frequency on G700 for high spurious or deviation
• check the UHF-VC on pin 21 N700 1,9V-3.2V DC depending of the channel
• check the 5V VCP supply voltage on pin 13, 22 from N700 SUMMA
• check R733 33K Ω , R730 5K6 Ω , R731 2K2 Ω , C740 2,2nF
• change the oscillator
N700 SUMMA faulty / poor soldering
• check the 13MHz reference frequency pin 15 N700. (No frequency deviation higher ± 50Hz is allowed!)
• check the power supply voltage VRX_2 2,8V DC pin 35 N600
• check the incoming IF 71MHz pin 37,38 N700
• check the 13MHz IF on pin 30(out),25, 26(in) N700 . The attenuation between input and output are ≈ 20dBm
• check the control-lines for the PLL pin 5, 6, 7 from N700 (see the diagrams below)
• check the incoming VHF_LO frequency 464MHz pin 8 N700 if the 13MHz IF are deviated or not exist
measurable level approximate –20dBm!
• Check the synth. power supply 2,8V DC pin 9, 19 N700 and VCC G700, G702
• Check the VCP 5V DC pin 13, 22 N700
• Check the control voltage for the UHF and VHF oscillator
(UHF pin 21 control voltage is channel dependent, pin12 2,2V DC on N700)
• Check the soldering of N700 or change it
Figure 7: PLL-SCKL Signal