Radio Shack AO0161AAA1 User Manual

Channel gmrs/frs two-way radio, Package contents, Ac p

Advertising
background image

©

2003 RadioShack Corporation.

All Rights Reserved.

RadioShack, RadioShack.com, and Adaptaplug are trademarks

used by RadioShack Corporation.

www.radioshack.com

SM

AO0161AAA1

05A03

Printed in China

21-1905

22-Channel GMRS/FRS Two-Way Radio

1. Turn off the radio by rotating

VOL/OFF

clockwise until it clicks.

2. Pull down the latch on the battery compartment cover and remove the cover.

3. Set

CHARGE ON/OFF

inside the battery compartment to

ON

if you use rechargeable

batteries or to

OFF

if you use non-rechargeable batteries. Install the batteries

according to the polarity symbols (+ and ) marked inside.

4. Replace the cover and push the latch up until it clicks. Then rotate

VOL/OFF

counterclockwise until it clicks to turn on the radio.

appears on the display to indicate the amount of battery power remaining . When

²

flashes, replace alkaline batteries or recharge Ni-Cd or Ni-MH batteries.

U

SING

AC P

OWER

/

V

EHICLE

B

ATTERY

P

OWER

You can charge the batteries in the radio from a
standard AC outlet or even your vehicle using a 6V,
series-regulated, DC adapter and a size F Adaptaplug™
adapter (neither supplied). Both are available at your
local RadioShack store.

1. Rotate

VOL/OFF

counterclockwise until it clicks to

turn off the radio.

2. Pull down the latch on the battery compartment

cover. Then remove the cover.

3. Set

CHARGE ON/OFF

to

ON

.

4. Install the batteries according to the polarity

symbols (+ and ) marked inside.

5. Replace the cover and push the latch up until it

clicks. Then rotate

VOL/OFF

counterclockwise until it

clicks to turn on the radio.

Using Keylock

To lock or unlock the keypad, hold down

FUNC

and press

PTT

to lock or unlock

the keys.

appears when the keys are locked. When the keypad is locked,

you can still transmit (press

PTT

), send a call (press

CALL

) or temporarily

enable/disable Vox (press

PTT

when Vox level is 1–4).

PTT

1. Hold down

PTT

to talk.

2. Release

PTT

to receive.

If you hold down

PTT

for about two-minutes, the radio

automatically stops transmitting to save power.

Using a Headset

You can make or answer calls
with handsfree convenience
using an optional headset with
a

3

/

32

-inch plug (not supplied,

available at your local
RadioShack store). To
connect a headset, insert the
headset’s plug into the

MIC

/

SPK

jack on the bottom of

the radio

OFF/VOLUME

Rotate

VOL/OFF

counterclockwise to turn on the

radio and adjust the volume. Rotate

VOL/OFF

clockwise to turn the radio off.

UP/DOWN

Press

or

to select a channel, quiet code, or use

scan.

Thank you for purchasing a RadioShack
22-Channel GMRS/FRS Two-Way Radio.
You can use your radio to communicate at
almost any time. You can talk to your
friends in the next room, next door, and
around the neighborhood. Your radio
transmits and receives on General Mobile
Radio Service (GMRS) and Family Radio
Service (FRS) frequencies. See your
Owner’s Manual for licensing information.

Radio (1)

PACKAGE CONTENTS

You can use four AA Ni-MH batteries,
or four AA Ni-Cd batteries, or four AA
alkaline batteries (none supplied) to
power your radio. Batteries are
available at your local RadioShack
store or online at
www.radioshack.com. You can
recharge Ni-MH batteries in the radio
using an optional smart charger or
AC or DC adapter. It takes about 2
hours for Ni-MH or Ni-Cd batteries to
charge using a smart charger or 10
hours using an AC or DC adapter.

o

WARNING

o

If you use non-rechargeable batteries, be sure to
set CHARGE ON/OFF to OFF. Non-rechargeable
batteries can get hot and explode if you try to
recharge them.

!

IMPORTANT

!

Do not open your radio to make any internal
adjustments. Your radio is set up to transmit
a regulated signal on an assigned
frequency. It is against the law to alter or
adjust the settings inside the radio to
exceed those limitations. Any adjustments
made to your radio must be made by a
qualified technician using the proper test
equipment. Never open your radio's case.
Never change or replace anything in your
radio except the batteries.

Selecting Quiet Codes

There are 38 codes to choose from. See your Owner’s
Manual for a listing of the Quiet Codes.

To select the desired quiet code, hold down

FUNC

.

FUNC

appears on the display. Repeatedly press or hold

e

or

d

until you see the code number you want to use.

To turn off the quiet code feature, hold down

FUNC

and

repeatedly press or hold

e

or

d

at the same time until

the quiet code number disappears.

U

SING

K

EY

T

ONE

AND

V

IBRATE

You can set the radio so it sounds a tone when you press any key except

PTT

or

FUNC

. You can also set the radio to vibrate when it receives a signal after the

radio is idle for 30 seconds.

To turn on the key tone and vibrate feature, press

MENU

to activate the Menu

function and press

e

or

d

until

and

ON

appear. Press

PTT

to store the

setting. Repeat these procedures to turn off the key tone and vibrate feature.

and

OFF

disappears. Press

PTT

to store the setting.

To turn on the key tone and turn off the vibrate feature, press

MENU

to activate

the Menu function and press

e

or

d

until

and

ON

appears. Press

PTT

key to

store the setting.

To turn off the key tone and turn on the vibrate feature, press

MENU

to activate

the Menu function and press

e

or

d

key until

and

ON

appears. Press

PTT

to

store the setting.

When you do not press a key after 20 seconds, while in the Menu, the radio
exits the Menu without saving your settings.

R

ESETTING

THE

R

ADIO

If the radio’s display locks up or the radio does not work properly after you turn
it on, turn it off and then on again. If this does not correct the problem, remove
the batteries, wait about ten minutes, then reinstall them.

Using Scan

Press and hold

e

or

d

to scan up or down to find the desired channel and quiet

code. The radio automatically scans through the channels and pauses on each
active channel. While scanning, press

e

or

d

to change the scanning direction.

Press

PTT

to stop scanning

Using VOX

Vox operation allows you to transmit a voice message
without pressing any key. To activate Vox, continuosly
press

MENU

until

VOX

appears. Press

e

or

d

to select

the desired level (1– 4). Select

OFF

to turn Vox off.

Press

PTT

to store the setting. When you do not press

any key after 20 seconds, while in the Menu, the radio
exits the Menu without saving your settings.

OPERATION

INSTALLING BATTERIES

OPTIONAL ACCESSORIES

Owner’s Manual

Quick Start

Belt Clip

Headset with Mic

Alkaline Batteries

Cigarette-Lighter Adapter

Leather Carrying Case

Size F Adaptaplug

TM

Connector

Smart Charger

6V 1000 mA
AC Adapter

6V

1000 mA

Advertising
This manual is related to the following products: