Preparation, Powering the cb, Using the power jack and ni/al switch – Ricoh TRC-239 User Manual
Page 6: You must set, Cor- rectly. follow these steps to set, As follows: • set it to
6
PREPARATION
POWERING THE CB
You can power your TRC-239 from any of these
sources:
• internal batteries (not supplied)
• vehicle battery power (using an optional
adapter)
• household AC power (using an optional adapter)
Using the POWER Jack and NI/AL
Switch
The
POWER
jack lets you connect an external power
source (such as your vehicle’s battery) or an external
AC adapter (not supplied), or an external charger
(not supplied) to charge rechargeable batteries (not
supplied) while they are in the TRC-239. Before con-
necting anything to
POWER
, you must set
NI/AL
cor-
rectly.
Follow these steps to set
NI/AL
.
1. Slide the battery compartment cover in the direc-
tion of the arrow to remove it.
2. Remove any installed batteries.
3. Set
NI/AL
as follows:
• Set it to
AL
to use alkaline batteries.
NI
AL
R
SERIAL
NUMBER
FOR RADIOSHACK. A DIVISION OF TANDY
CUSTOM MANUFACTURED IN THAILAND
CORPORATION. FORT WORTH. TEXAS 76102
FCC ID: AAO2101678
(1) This device may not cause harmful interference, and
including interference that may cause undesired operation.
(2) this device must accept any interference received,
Operation is subject to the following two conditions:
This device complies with Part 15 of FCC Rules.
AA
AA
AA
21-1628.fm Page 6 Tuesday, January 25, 2000 9:30 AM