Ryobi R1801M1 - Manual (Page 12)

12
Fig. 5
REMOVING/INSERTING CUTTERS
See Figure 5.
Follow these steps to remove or insert cutters.
1. Unplug the router.
WARNING:
Failure to unplug the tool could result in accidental start-
ing causing serious injury.
CAUTION:
To prevent damage to the spindle or spindle lock, al-
ways allow the motor to come to a complete stop before
engaging the spindle lock.
2. Place the router upside down on a workbench in order
to gain easy access to collet nut.
3. Depress the gold spindle lock button.
4. Loosen the collet nut by turning it counterclockwise
with the wrench provided.
WARNING:
If you are changing a cutter immediately after use, be
careful not to touch the cutter or collet with your hands or
fingers. They will get burned because of the heat buildup
from cutting. Always use the wrench provided.
5. Choose one of these options:
■ To remove the cutter:
Remove the cutter from the collet.
■ To insert the cutter:
a) Insert the shank of the cutter until the shank
bottoms out, then pull it out 1/16 in. (1.6 mm) to
allow for expansion when the bit gets hot.
b) Tighten the collet nut securely by turning it
clockwise with the wrench provided.
c) Release the gold spindle lock button.
WARNING:
If the collet nut is not securely tightened, the cutter may
detach during use causing serious personal injury.
WARNING:
Do not use cutters with undersized shanks. Undersized
shanks will not tighten properly and could be thrown
from the tool causing injury.
WARNING:
Do not use cutters that are larger in diameter than the
opening in router subbase. Use of such cutters will
come in contact with the router subbase and damage
both the cutter and router. The use of larger cutters
could also cause possible loss of control or create other
hazardous conditions that could result in serious per-
sonal injury or death.
OPERATION
TO
LOOSEN
TO
TIGHTEN
GOLD
SPINDLE LOCK
BUTTON