RedMax EBZ8050 - Manual (Page 8)

US-8
EBZ8050/RH
6. Set up
■ BLOWER TUBES
1. Connect the blower and swivel joint
with flexible hose. Clamp both ends of
the flexible hose securely with the
hardware supplied with the unit.
2. Align the protrusion and the groove
provided on the tube ends and twist the
tube until connection is locked up.
A light lubricant may be used to ease
assembly of flexible pipe to blower
elbow.
■ THROTTLE LEVER
[EBZ8050RH]
• Set up the clamp to the swivel and
tighten the screw on the clamp.
(1) Clamp
(2) Swivel
(3) Screw
■ THROTTLE CABLE
[EBZ8050RH]
• Use the clamp to fasten the colgate
tube containing the throttle cable and
the power cable to the hose.
(1) Clamp
(2) Cable
(3) Hose
NOTE
F1
F2 [EBZ8050RH]
F3 [EBZ8050RH]
F4
■ WAIST BELT (OPTIONAL
ACCESSORY)
• The waist belt is attached to the hooks
on the left and right sides of the frame.
• Be sure to always tighten the buckle in
front of your body.
• If you are not using a waist belt, be
sure to remove it from the unit and
store it.
• There is a risk that the belt will be
caught, toppling the unit.
• There is a danger that the belt will be
sucked into the fan.
WARNING