Ryobi TS1551 - Manual (Page 17)

Page 17
30
15
0
15
30
ADJUSTMENTS
The edge of the square and the saw blade should be
parallel as shown in figure 21.
If the front or back edge of the saw blade angles away
from the square as shown in figures 22 and 23, adjust-
ments are needed.
Loosen the socket head screws that secure the miter
fence to the miter table. See Figure 20.
Rotate the miter fence left or right until the saw blade is
parallel with the square.
Retighten the screws securely and recheck the blade-
to-fence alignment.
Your saw has two scale indicators, one on the bevel scale
and one on the miter scale. After squaring adjustments have
been made, it may be necessary to loosen the indicators
screws and reset them to zero. See Figure 24.
MITER
TABLE
BLADE
MITER
LOCK HANDLE
Fig. 21
MITER
TABLE
VIEW OF BLADE
SQUARE WITH FENCE
BLADE
MITER
FENCE
MITER
LOCK
PLATE
FRAMING
SQUARE
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
FRAMING
SQUARE
MITER
FENCE
Fig. 22
MITER
FENCE
Fig. 23
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
FRAMING
SQUARE
MITER
TABLE
BLADE
SCALE
INDICATOR
Fig. 24
MITER
SCALE 15
0
45
BEVEL
SCALE
INDICATOR
SCREW
INDICATOR
POINT
SCALE
INDICATOR
INDICATOR
SCREW