Radio Shack 3-IN-ONE POCKET REMOTE CONTROL 15-1990 - Manual (Page 7)

7
3. Hold down P until the red light blinks twice, then
enter the 4-digit code you wrote down in Step 1
using these keys:
For example, to replace a TV’s remote control
(manufacturer’s code 1432), press
TV , hold
down P until the red light blinks twice, then press
VOL + , CH – , CH + , and VOL – .
When the red light blinks twice, the remote con-
trol has accepted the code.
Note: If the code you entered is invalid, the red
light blinks.
4. Point the remote control at your device and
press POWER . Your device should turn off (or
on, if it was off).
If the remote does not operate your device, try
the other codes listed in “Manufacturers’ Codes”
on Page 11 for your brand of TV, VCR, TV/VCR
combination, or cable converter.
5. Repeat Steps 2–4 for additional devices.
Press
To Enter
This Number
VOL + 1
VOL – 2
CH + 3
CH – 4
MUTE 5
15-1990.fm Page 7 Tuesday, December 14, 1999 12:45 PM