Features, Operation, Warning – Ryobi VC722 User Manual
Page 7: Caution
7
CHARGING YOUR HAND VAC
The battery pack for your hand vac has been shipped in a
low charge condition to prevent possible problems. There-
fore, you should charge it overnight prior to use.
NOTE: Batteries will not reach full charge the first time
they are charged. Allow several cycles (vacuuming fol-
lowed by recharging) for them to fully charge.
■
Charge only with the charger provided.
■
After normal usage, 3 hours or less of charging time
is required to fully recharge hand vac. NOTE: If hand
vac is completely discharged, 6 hours or longer of
charging time is required to fully recharge battery.
■
While charging, it is normal for the charger to become
warm to the touch.
■
Do not place charger in an area of extreme heat or
cold. It will work best at temperatures above 50°F and
below 100°F.
Fig. 2
FEATURES
PRODUCT SPECIFICATIONS:
HAND VAC
VC722
Motor
7.2 Volt, DC
Switch
On/Off
CHARGER
Item No. 7222701
BATTERY
Item No. 1311145
Charger Rating
120V, 60 Hz, AC Only
Charger Voltage
7.2 Volt
Charger Rate
3-6 Hours
OPERATION
WARNING:
If any parts are missing, do not operate unit until
the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
CAUTION:
To prevent damage to battery pack, remove battery
pack from charger immediately if no LED comes on.
Return battery pack and charger to your nearest
Ryobi Authorized Service Center for checking or
replacing. Also, if you are removing battery pack
from charger and no LED is on, return both battery
pack and charger to your nearest Ryobi Authorized
Service Center. Do not insert another battery pack
into charger. A defective charger may damage a
battery pack.
TO CHARGE HAND VAC’S BATTERY PACK
WITHOUT USING CRADLE
See Figure 2.
■
Charge hand vac only with the charger provided.
■
Insert charger plug into input jack of battery pack
making sure it is properly connected.
See Figure 2.
■
Make sure power supply is normal household
voltage, 120 volts, 60 Hz, AC only.
■
Connect charger to power supply. The LED indicator,
will light up when charger is properly connected to
power supply. This light indicates that proper charg-
ing is occuring. It will remain on until charger has been
disconnected from power supply.
BATTERY
PACK
CHARGE
INDICATOR
LIGHT (LED)
CHARGER
CHARGER PLUG
INTO INPUT JACK